Yamaha CLP-611 Owner's Manual - Page 43
AUX IN R and L/L+R, AUX OUT R and L/L+R, TO HOST connector
View all Yamaha CLP-611 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
MIDI IN OUT THRU HOST SELECT PC-2 PC-1 MIDI Mac TO HOST AUX IN R L/L+R AUX OUT R L/L+R AC INLET 6 IN MIDI OUT THRU 78 HOST SELECT PC-2 PC-1 MIDI Mac TO HOST AUX IN R L/L+R AUX OUT R L/L+R 4 AUX IN jacks (R and L/L+R) 5 AUX OUT jacks (R and L/L+R) 45 • AUX IN R and L/L+R These standard phone jacks accept Clavinova connection from a synthesizer, tonegenerator module (such as the YAMAHA DOU-10 Disk Orchestra MIDI IN OUT THRU HOST SELECT PC-2 PC-1 MIDI Mac TO HOST AUX IN R L/L+R AUX OUT R L/L+R Unit), or other such playback device. Sound transmitted from the external device is produced by the Clavinova's internal speakers. Make the connection (using standard Standard phone plugs AUX IN Audio cord audio cord) as illustrated at right. NOTE A line-level mono source can be connected to the L/L+R jack. OUTPUT DOU-10 or Synthesizer, tonegenerator module,... • AUX OUT R and L/L+R You use these standard phone jacks to feed Clavinova output to an external stereo recorder, Clavinova MIDI IN OUT THRU HOST SELECT PC-2 PC-1 MIDI Mac TO HOST amplifier, or other such device. AUX IN R L/L+R AUX OUT R L/L+R This makes it possible, for example, to record the sound to a tape recorder or cassette, or Standard to produce it through external phone plugs AUX OUT or speakers. Make the connection (using standard audio cord) as shown above. Pin-phone adaptors Pin plugs Audio cord Stereo AUX IN Pin plugs When connecting to a stereo unit, set the [MASTER VOLUME] slider to center position and adjust the volume at the recording side. NOTE If a line is inserted into the L/L+R jack only, the Clavinova mixes left- and rightchannel signals and outputs them over this line. This ensures that you don't lose any of the Clavinova's sound. 6 MIDI IN, OUT, and THRU connectors These are used to connect to external MIDI devices. Note that you must set the HOST SELECT switch (described below) to MIDI in order to enable use of these connectors. For basic information about MIDI connections and operation, refer to page 48. 7 HOST SELECT switch, and 8 TO HOST connector TO HOST connector.... Allows direct connection to a personal computer. HOST SELECT switch... Sets the connection type. If connecting directly to a personal computer, you use this switch to select the computer type. If connecting via MIDI, set this switch to the MIDI position. Refer to "Connecting to a Personal Computer" (page 40) for detail. (CLP-811) Never feed AUX OUT output back into the AUX IN jacks. When using AUX OUT to connect to an external device, do not connect that device back to the AUX IN at the Clavinova side. Since the AUX OUT signal always includes all sound received at the AUX IN jacks, interconnection will create a feedback loop that will distort the sound and may cause damage to your equipment. Audio cord (and adaptors, if required) should be nonresistance type. The Clavinova's [MASTER VOLUME] slider and REVERB setting do not affect the sound received at the AUX IN jacks. CLP-811/611 The Clavinova's Device Connectors 39