Yamaha CLP-611 Owner's Manual - Page 54

1. NOTE ON/OFF [9nH] → [kkH] → [vvH] 9nH = Note ON/OFF event (n = Channel No.) kkH = Note No. (Sending: 09H~78H = A-2~C8) (Receiving: 00H~7FH = C-2~G8) *1 vvH = velocity (Note ON = 01H~7FH. Note OFF = 00H.) [8nH] → [kkH] → [vvH] 8nH = Note OFF (n = Channel No.) kkH = Note No. (00H~7FH = C-2~G8) vvH = velocity *1: If received value exceeds the supported range for the selected voice, the note is adjusted by the necessary number of octaves. 2. Control Change [BnH] → [ccH] → [vvH] BnH = Control Change (n = Channel No.) ccH = Control No. vvH = Control value 1) Bank Select ccH Parameter Value (vvH) 00H Bank select MSB 01H: Normal 00H~7FH: Incorrect sounding 20H Bank select LSB 00H~7FH 70H Brilliance: Normal Variation: OFF 71H Normal ON 72H Bright OFF 73H Bright ON 74H Mellow OFF 75H Mellow ON * Bank selection processing does not occur until receipt of next Program Change message. * Bank Select messages are not effective on the Organ Combination voice. 2) Main Volume (Receive only) ccH Parameter Value (vvH) 07H Volume 00H~7FH 3) Expression ccH Parameter 0BH Expression Value (vvH) 00H~7FH 4) Damper Pedal ccH Parameter Value (vvH) 40H Damper 00H~7FH 5) Sostenuto Pedal ccH Parameter Value (vvH) 42H Sostenuto 00H~3FH:OFF 40H~7FH:ON 6) Soft Pedal ccH Parameter 43H Soft pedal Value (vvH) 00H~3FH:OFF 40H~7FH:ON 7) Attack Time ccH Parameter 49H Attack time Value (vvH) 00H~7FH 8) Effect-1 Depth (Reverb Send Level) ccH Parameter Value (vvH) 5BH Effect-1 depth 00H~7FH * Adjusts the send level for the reverb effect. 9) Effect-4 Depth (Variation-Effect Send Level) ccH Parameter Value (vvH) 5EH Effect-4 depth 00H~7FH 3. Mode Messages [BnH] → [ccH] → [vvH] BnH = Control Event (n = Channel No.) ccH = Mode Message No. vvH = Mode Message value 1) All Sound Off ccH Controller Value (vvH) 78H All Sound Off 00H * Turns off all sound on the specified channel. Does not reset Note On and Hold On conditions established by Channel Messages. 2) Reset All Controllers ccH Controller Value (vvH) 79H Reset All Controllers 00H * Resets controllers as follows. Controller Reset Value Expression 127 (Max.) Damper Pedal 0 (OFF) Sostenuto 0 (OFF) Soft Pedal 0 (OFF) 3) All Notes Off ccH Controller 7BH All Notes Off Value (vvH) 00H * Switches OFF all the notes that are currently ON on the specified channel. Any notes being held by the damper or sostenuto pedal will continue to sound until the pedal is released. 4) Omni Off (Receive only) ccH Controller Value (vvH) 7CH Omni Off 00H * Same processing as All Notes Off. 5) Omni On (Receive only) ccH Controller Value (vvH) 7DH Omni On 00H * Same processing as All Notes Off. 6) Mono (Receive only) ccH Controller Value (vvH) 7EH Mono 00H * Same processing as All Sound Off. 7) Poly (Receive only) ccH Controller Value (vvH) 7FH Poly 00H * Same processing as All Sound Off. q Remarks 1. The Clavinova will not send or accept Control Change messages if the FUNCTION-mode Control Change setting is OFF. 2. The Clavinova does not transmit Local ON/OFF and Omni ON/OFF messages. (All Notes Off is transmitted as a series of Note Off messages.) 3. The Clavinova saves the bank select value (MSB and LSB; receivable in any order) to its internal buffer. This value is then used to determine the voice selection upon receipt of the next Program Change message. 4. The Clavinova always operates in multitimbral polyphonic mode. The mode does not change in response to Omni ON/OFF, Mono, and Poly messages. 4. Program Change [CnH] → [ppH] CnH = Program Change (n = Channel No.) ppH = Program Change No. * The Clavinova will not send or accept Program Change messages if the FUNCTION-mode Program Change setting is OFF. * Program number assignments are as follows. Voice PIANO 1 PIANO 2 CLAVI. TONE E. PIANO 1 E. PIANO 2 HARPSICHORD VIBES STRINGS Program Change No. 00H 01H 58H 05H 04H 06H 0BH 30H CHOIR 34H PIPE ORGAN 13H ORGAN CONBINATION 10H BASS (CLP-811) 20H 5. System Realtime Messages 1) Active Sensing [FEH] * Transmitted every 200 msec. * If the Clavinova receives no MIDI signals for 400 msec. following receipt of an FEH, it will execute processing equivalent to All Sound Off → All Notes Off → Reset All Controllers. 2) Clock [F8H] * Clock signal is issued 96 times per whole note. * If Exclusive Message specifies use of an external clock, the Clavinova counts 96 clock signals as one whole note. 3) Start [FAH] * Transmitted at rhythm start. * Receipt causes song to start. 4) Stop [FCH] * Transmitted at rhythm stop. * Receipt causes song to stop. * If error occurs during MIDI reception, the Clavinova switches off damper, sostenuto, and soft effects and then executes All Notes Off processing (for all channels). 6. System Exclusive Message (Yamaha MIDI Format) [F0H] → [43H] → [0nH]→ [7CH F7H] F0H,43H,0nH,7CH: n = Channel No. 01H,36H: Data length 43H,4CH,20H,20H: CL 43H,4CH,50H,27H,39H,36H: CLP'96 30H,30H: (Version x,y) [Panel Data] [Checksum (1 byte)]=0-(43H+4CH+20H+..... data end) F7H: End of Exclusive [Panel-data content] (1) Voice (2) DUAL ON/OFF (3) DUAL voice (4) DUAL balance (5) DUAL detuning (6) DUAL Voice#1 octave shift (7) DUAL Voice#2 octave shift (8) DUAL Voice#1 effect depth (9) DUAL Voice#2 effect depth (10) DUAL/STRINGS slow attack ON/OFF (11) SPLIT ON/OFF (12) SPLIT voice (13) SPLIT point (14) SPLIT balance (15) SPLIT Voice#1 octave shift (16) SPLIT Voice#2 octave shift (17) SPLIT Voice#1 effect depth (18) SPLIT Voice#2 effect depth (19) SPLIT damper mode (20) Reverb type (21) Reverb depth (22) Effect type 1 (23) Effect type 2 (24) Effect depth (25) Brilliance (26) Variation #1 ON/OFF (27) Variation #2 ON/OFF (28) Touch sensitivity (29) FIXED-touch velocity (30) Left pedal function (Soft/Start) (31) Key-specific tuning ON/OFF (32) Tempo (absolute value; LSB) (33) Tempo (absolute value; MSB) (34) Organ Combination voice No. (35)~(51) Organ Combination data 1 50 CLP-811/611 MIDI Data Format/MIDI-Datenformat/Format de données MIDI/Formato de datos MIDI