Yamaha DTXTREME Owner's Manual (reference Section) - Page 55

REFERENCE SECTION Drum Kit Effect Edit Mode Chorus Unit [Chorus] Chorus1 In this page, you can specify details of the chorus effect. This is a system effect and affects the entire drum kit. Note that this effect is unavailable when the Localizer is enabled in the [Effect] page (page 54). [Chorus] Type LFO CHORUS1 0.25Hz 1 2 Depth FBLeval 54 +13 3 4 1 Type Choose a chorus type. As system effect, you can choose from the following 14 types. ❏Settings: NONE, CHORUS1, CHORUS2, CHORUS3, CHORUS4, CELESTE1, CELESTE2, CELESTE3, CELESTE4, FLANGER1, FLANGER2, FLANGER3, SYMPHNIC, ENSEMBLE, PHASER About CHORUS Parameters 2 - 4 Edit parameters will vary depending on the chorus type you have chosen in the [Chorus1] page. Refer to the Effect Type List in the Appendix for details. [Chorus] Chorus2 Continued from the [Chorus1] page, set parameters for the chorus type you have chosen. Note that this effect is unavailable when the Localizer is enabled in the [Effect] page (page 54). Edit parameters will vary depending on the chorus type you have chosen in the [Chorus1] page. Refer to the Effect Type List in the Appendix for details. Insertion Units [InsFX] INS FX SETUP1/2 In these pages, you can set parameters for each insertion effect you want to apply to a specific voice in the drum kit. Note that the insertion effects are unavailable when the Localizer is enabled in the [Effect] page (page 54). [InsFX] Type DRY/WET L>RDlay R>LDlay FX=1 CROSSDELAY (D=W) 170.0 170.0 1 2 Procedure 1. Use the Data Control knob assigned to "FX=" and choose either insertion effect 1 or 2. 2. Use the Data Control knob assigned to "Type" and assign an effect type to the insertion effect you have chosen. Parameters for the effect type will be displayed. 3. Select an edit page using the Page v and w buttons and find the page containing the parameter you want to edit. 4. Enter the value using the Data Control knob assigned to your desired parameter. n Turning the Data Control knob while holding down the SHIFT button increases or decreases the value in larger increments. 5. Repeat steps 3 to 4 and set any necessary parameters. 6. If necessary, go back to step 1 and switch to the other insertion effect in order to set it up following steps 2 to 5. n Available edit pages and parameters may vary depending on the effect type you choose. Refer to the Effect Type List in the Appendix for details. 1 FX= Choose the target insertion effect. ❏Settings: FX=1 (insertion effect 1), FX=2 (insertion effect 2) 55