Yamaha ELS-02 Owner's Manual - Page 110

Using the MDR Display Precautions when using the [USB TO DEVICE] terminal This instrument is equipped with the three [USB TO DEVICE] terminals as follows: • Two [USB TO DEVICE] terminals in the USB Dock at the left front of the keyboard. • One [USB TO DEVICE] terminal at the right side under the keyboard. NOTE For more information about the handling of USB devices, refer to the owner's manual of the USB device. Compatible USB devices • USB flash memory • USB-LAN adaptor • USB wireless adaptor (which is included only in some areas) Other USB devices such as a computer keyboard or mouse cannot be used. Although USB devices 1.1 to 3.0 can be used on this instrument, the amount of time for saving to or loading from the USB device may differ depending on the type of data or the status of the instrument. The instrument does not necessarily support all commercially available USB devices. Yamaha cannot guarantee operation of USB devices that you purchase. Before purchasing a USB device for use with this instrument, please visit the following web page: http://download.yamaha.com/ NOTE The rating of the [USB TO DEVICE] terminal is a maximum of 5V/ 500mA. Do not connect USB devices having a rating above this, since this can cause damage to the instrument itself. Connecting USB device When connecting a USB device to the [USB TO DEVICE] terminal, make sure that the connector on the device is appropriate and that it is connected in the proper direction. USB Dock NOTICE • Avoid connecting or disconnecting the USB flash memory while executing playback/recording and file management operations (such as Save, Copy, Delete and Format), or when accessing the USB flash memory. Failure to observe this may result in "freezing" of the operation of the instrument or corruption of the USB flash memory and the data. • When connecting then disconnecting the USB flash memory (and vice versa), make sure to wait more than 6 seconds between the two operations. • When connecting a USB cable, make sure that the length is less than 3 meters. Using USB flash memories By connecting the instrument to a USB flash memory, you can save data you've created to the connected device, as well as read data from the connected device. Maximum number of USB flash memories allowed Up to three USB flash memories can be connected to the [USB TO DEVICE] terminal. Formatting USB flash memory You should format the USB flash memory only with this instrument (page 111). A USB flash memory formatted on another device may not operate properly. NOTICE The format operation overwrites any previously existing data. Make sure that the USB flash memory you are formatting does not contain important data. Proceed with caution, especially when connecting multiple USB flash memory. To protect your data (write-protect) To prevent important data from being inadvertently erased, apply the write-protect provided with each USB flash memory. If you are saving data to the USB flash memory, make sure to disable write-protect. Turning off the instrument When turning off the instrument, make sure that the instrument is NOT accessing the USB flash memory by playback/recording or file management (such as during Save, Copy, Delete and Format operations). Failure to do so may corrupt the device and the data. NOTE • For details about the USB Dock, see page 189. • When you use a USB device other than a USB flash memory, connect it to the [USB TO DEVICE] terminal on the right side under the lower keyboard. 110 ELS-02/ELS-02C Owner's Manual