Yamaha ELS-02 Owner's Manual - Page 48

Sustain, Brilliance, To add sustain to the Voices and call up, the Sustain Length display

Page 48 highlights

Selecting from the Panel  RHYTHM Determines the amount of reverb applied to the rhythm (with PERCUSSION slider) and accompaniment (with ACCOMPANI. slider). Each slider corresponds to the REVERB slider in the Rhythm Condition display. Range:0 - 24 Reference page • Changing the rhythm reverb (page 60)  KEYBOARD PERCUSSION Determines the amount of reverb applied to the Keyboard Percussion. Range:0 - 24 Reference page • Keyboard Percussion (page 68) Sustain The sustain effect, selectable for each Voice section, causes Voices to gradually fade out when the keys are released. The sustain on/off and sustain length settings are independent for each keyboard, providing maximum expressive control. The Knee Lever can also be used to switch the sustain on/ off. Sustain cannot be applied to the Lead Voices. Reference page • Knee Lever (page 174) To add sustain to the Voices and call up the Sustain Length display: Press one of the SUSTAIN buttons, located to the left of the panel, to set the sustain. The SUSTAIN LENGTH display appears. SUSTAIN UPPER (KNEE) LOWER (KNEE) PEDAL The lamp of the button lights up to indicate that sustain is on. Press the button again to turn sustain off and the lamp turns off. When the lamp is off, sustain does not affect the corresponding keyboard. Remember to check whether the sustain button lamps are on or off before you start to play. SUSTAIN LENGTH display To adjust the sustain length value, use the display slider. If you set the highest value (HOLD), some Voices such as organ or synth will sound continuously even when the keys are released. Range:0 - 12, HOLD NOTE • If you change the Voice when the sustain length is set to HOLD and the keys are released, the Voice only changes after you play another key. • When the sustain length is set to HOLD, previously played note(s) may be cut off by subsequently played notes. • The minimum setting results in no sustain. Turning sustain off automatically resets the sustain length to be the default setting. • Only "HOLD" is available for the Voices listed below. No effect is produced when a value of 0 - 12 is set. S-Violin 1/ 2 S-Tenor Sax 1/2/3 S-Trumpet 1/2 S-TenorSax Growl S-Trombone S-Soprano Sax S-Flute S-SprnoSax Growl S-Flute Flutter S-Harmonica S-Clarinet 1/2 S-BluesHarp S-Alto Sax S-Pan Flute 1/2 S-Alto Sax Growl S-Irish Pipe 1/2 Brilliance Adjustment of the Voice tone, brighter or mellower. Press the BRILLIANCE buttons of each Voice section on the panel to set the desired brilliance for each Voice. The buttons have seven brilliance settings. UPPER KEYBOARD VOICE 1 STRINGS BRASS WOODWIND TUTTI PAD SYNTH BRILLIANCE VOLUME BRILLIANT MAX 1 PIANO ORGAN PERCUSSION GUITAR CHOIR WORLD 2 MELLOW MIN 48 ELS-02/ELS-02C Owner's Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206

Selecting from the Panel
ELS-02/ELS-02C Owner’s Manual
48
3
RHYTHM
Determines the amount of reverb applied to the rhythm
(with PERCUSSION slider) and accompaniment (with
ACCOMPANI. slider). Each slider corresponds to the
REVERB slider in the Rhythm Condition display.
Range:
0 – 24
Reference page
• Changing the rhythm reverb (page 60)
4
KEYBOARD PERCUSSION
Determines the amount of reverb applied to the
Keyboard Percussion.
Range:
0 – 24
Reference page
• Keyboard Percussion (page 68)
The sustain effect, selectable for each Voice section,
causes Voices to gradually fade out when the keys are
released. The sustain on/off and sustain length settings
are independent for each keyboard, providing maximum
expressive control.
The Knee Lever can also be used to switch the sustain on/
off. Sustain cannot be applied to the Lead Voices.
Reference page
• Knee Lever (page 174)
To add sustain to the Voices and call up
the Sustain Length display:
Press one of the SUSTAIN buttons, located to the left of
the panel, to set the sustain. The SUSTAIN LENGTH
display appears.
The lamp of the button lights up to indicate that sustain is
on. Press the button again to turn sustain off and the
lamp turns off. When the lamp is off, sustain does not
affect the corresponding keyboard.
Remember to check whether the sustain button lamps are
on or off before you start to play.
SUSTAIN LENGTH display
To adjust the sustain length value, use the display slider. If
you set the highest value (HOLD), some Voices such as
organ or synth will sound continuously even when the
keys are released.
Range:
0 – 12, HOLD
NOTE
If you change the Voice when the sustain length is set to HOLD
and the keys are released, the Voice only changes after you play
another key.
When the sustain length is set to HOLD, previously played note(s)
may be cut off by subsequently played notes.
The minimum setting results in no sustain. Turning sustain off
automatically resets the sustain length to be the default setting.
Only “HOLD” is available for the Voices listed below. No effect is
produced when a value of 0 – 12 is set.
S-Violin 1/ 2
S-Tenor Sax 1/2/3
S-Trumpet 1/2
S-TenorSax Growl
S-Trombone
S-Soprano Sax
S-Flute
S-SprnoSax Growl
S-Flute Flutter
S-Harmonica
S-Clarinet 1/2
S-BluesHarp
S-Alto Sax
S-Pan Flute 1/2
S-Alto Sax Growl
S-Irish Pipe 1/2
Adjustment of the Voice tone, brighter or mellower.
Press the BRILLIANCE buttons of each Voice section on
the panel to set the desired brilliance for each Voice.
The buttons have seven brilliance settings.
Sustain
SUSTAIN
UPPER
(KNEE)
LOWER
(KNEE)
PEDAL
Brilliance
UPPER KEYBOARD VOICE
1
BRILLIANCE
VOLUME
BRILLIANT
MELLOW
MAX
MIN
STRINGS
BRASS
TUTTI
PAD
SYNTH
WOOD-
WIND
PIANO
ORGAN
GUITAR
CHOIR
WORLD
PERCUS-
SION
1
2