Yamaha MT1X Owner's Manual - Page 21

Setting the monitor and meter s

Get Yamaha MT1X PDF manuals and user guides View all Yamaha MT1X manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

4. Setting the monitor and meter sections Set the PHONES SELECT switch to the "STEREO" position. Set the PHONES volume to around "7". Make sure the METER SELECT switch is in the "4 TRK" position. 5. Adjusting the input level Set all of the input switches to the MIC/LINE position. Set the MASTER fader to "7". Set the PAN controls for all channels between the center and the extreme "L" position, as shown. 19 Push the input fader for channel 1 up to "7". When the drums start playing, slide the gain control for channel 1 towards the "MIC", direction, stopping when the "+3" indicator on the far left level meter flashes occasionally on the sound peaks. Pull the input fader for channel 1 back down to "0". -The proper input level for channel 1 is now set.- Set the input fader for channel 2 to "7". While the drums are being played, slide the gain control for channel 2 towards the "MIC" direction, stopping when the "+3" indicator on the far left level meter flashes occasionally on the sound peaks. Pull the input fader for channel 2 back down to "0': -The proper input level for channel 2 is now set.- Set the input levels for channels 3 and 4 the same way.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
4. Setting the monitor and meter sections
Set the PHONES SELECT switch to the “STEREO”
position.
Set the PHONES volume to around “7”.
Make sure the METER SELECT switch is in the “4
TRK” position.
5. Adjusting the input level
Set all of the input switches to the MIC/LINE
position.
Set the MASTER fader to “7”.
Set the PAN controls for all channels between the
center and the extreme “L" position, as shown.
Push the input fader for channel 1 up to “7”.
When the drums start playing, slide the gain con-
trol for channel 1 towards the “MIC”, direction, stop-
ping when the “+3” indicator on the far left level
meter flashes occasionally on the sound peaks.
Pull the input fader for channel 1 back down to “0”.
-The proper input level for channel 1 is now set.—
Set the input fader for channel 2 to “7”.
While the drums are being played, slide the gain con-
trol for channel 2 towards the “MIC” direction, stop-
ping when the “+3” indicator on the far left level
meter flashes occasionally on the sound peaks.
Pull the input fader for channel 2 back down to “0’:
-The proper input level for channel 2 is now set.-
Set the input levels for channels 3 and 4 the same
way.
19