2003 Ford Explorer Sport Trac Owner Guide 1st Printing (Spanish) - Page 297

Locks and Security 2. Close all the doors. 3. Enter the 5-digit entry code. 4. Press and hold the 3 • 4. While holding the 3 • 4, press the 7 • 8 within five seconds. 5. Within 5 seconds of Step 4, release the 3 • 4. 6. Within 5 seconds of Step 5, Release the 7 • 8. The horn will chirp once when the system has been successfully deactivated. The horn will chirp twice (one short and one long chirp) when the system has been successfully reactivated. To deactivate/reactivate the autolock feature using the ignition lock cylinder and interior power door locks control 1. Close all the doors. 2. Ensure that the ignition lock cylinder is in the OFF position. 3. Note: Steps 4 through 8 must be carried out within 30 seconds. Turn the ignition lock cylinder from OFF to RUN. 4. Press the power door locks UNLOCK control three times. 5. Turn the ignition lock cylinder from RUN to OFF. 6. Press the power door locks UNLOCK control three times. 7. Turn the ignition lock cylinder from OFF to RUN. 8. Ensure that the vehicle's horn chirps. This chirp indicates that the feature is in an enable/disable mode and ready to accept program changes. 9. Press the power door locks UNLOCK control once, then the LOCK control once, in order to toggle the autolock feature. 10. Ensure that the horn chirps once; there should only be one horn chirp, indicating that the autolock feature has been deactivated. If one chirp is heard, followed by a longer sound of the horn, the autolock feature has been reactivated. 11. Turn the ignition lock cylinder to the OFF position, or wait two minutes, in order to exit the enable/disable mode. 12. Exit the vehicle and ensure that the horn chirps once to indicate that a feature has been changed and that the autolock feature has been toggled. 67