2003 Ford Explorer Sport Trac Owner Guide 1st Printing (Spanish) - Page 418

Maintenance and Specifications • You may need to cycle the ignition from off to on several times after refueling to allow the fuel system to pump the fuel from the tank to the engine. • Your "Check Engine" indicator may come on. Fuel filler cap When fueling: 1. Turn the engine off. 2. Carefully turn the filler cap counterclockwise 1/8 of a turn until it stops. 3. Pull to remove the cap. 4. To install the cap, align the tabs on the cap with the notches on the filler pipe. 5. Turn the filler cap clockwise 1/8 of a turn until it stops. If the "Check Fuel Cap" indicator CHECK illuminates and stays on after you FUEL start the engine, the cap may not be CAP properly installed. If you must replace the fuel filler cap, replace it with a fuel filler cap that is designed for your vehicle. If you do not use the proper fuel filler cap, excessive pressure or vacuum in the fuel tank may damage the fuel system or cause the fuel cap to disengage in a collision, which may result in personal injury. Fuel filter Refer to the Scheduled Maintenance Guide for the appropriate replacement intervals. Replace the fuel filter with an authorized Motorcraft part. ESSENTIALS OF GOOD FUEL ECONOMY We do not recommend taking fuel economy measurements during the first 1,600 km (1,000 miles) of driving. You will get a more accurate measurement after 3,000 km - 5,000 km (2,000 miles - 3,000 miles) Filling the tank The advertised fuel capacity of the fuel tank on your vehicle is equal to the rated refill capacity of the fuel tank as listed in the Refill capacities section of this chapter. 188