2009 Mazda CX-9 Owner's Manual - Page 169
2009 Mazda CX-9 Manual
Page 169 highlights
Driving Your Mazda Starting and Driving WARNING Remove the key only when the vehicle is parked: Removing the key from the ignition switch while the vehicle is moving is dangerous. Removing the key allows the steering wheel to lock. You will lose steering control and a serious accident could occur. (For vehicles equipped with the advanced key, the steering wheel locks when the starter knob is turned to the LOCK position.) Before leaving the driver's seat, always put the key or start knob to LOCK position, set the parking brake and make sure the shift lever is in P: It is important to place the key or start knob in the LOCK position even if you are not removing the key from the ignition or leaving the vehicle. Leaving the key in other positions will disable some of the vehicle security systems and run the battery down. Leaving the driver's seat without putting the ignition switch in LOCK position, setting the parking brake and shifting the shift lever to P is dangerous. Unexpected vehicle movement could occur. This could cause an accident. NOTE If turning the key is difficult, jiggle the steering wheel from side to side. Leaving the key or start knob in any position but LOCK position also disables some of the security features and may run the battery down. ON This is the normal running position after the engine is started. The warning lights (except brakes) should be inspected before the engine is started (page 5-43). NOTE When the ignition switch is turned to the ON position, the sound of the fuel pump motor operating near the fuel tank can be heard. This does not indicate an abnormality. NOTE Vibration of the brake pedal may be felt when the ignition switch is turned to the ON position, however, this is a normal operation of the DSC/RSC and does not indicate an abnormality. START The engine is started in this position. It will crank until you release the key; then it returns to the ON position. The brake warning light can be checked after the engine is started (page 5-43). qIgnition Key Reminder If the ignition switch is in the LOCK or ACC position with the key inserted, a continuous beep sound will be heard when the driver's door is opened. ACC (Accessory) The steering wheel unlocks and some electrical accessories will operate. 5-3