Home » Mazda Manuals » 2009 Mazda CX-9 » Manual Viewer

2009 Mazda CX-9 Owner's Manual - Page 238

2009 Mazda CX-9 Manual

Get 2009 Mazda CX-9 PDF manuals and user guides

View all 2009 Mazda CX-9 manuals

Page 238 highlights

Driving Your Mazda Switches and Controls NOTE FCC ID: NZLOBIHL3 CANADA:4112A-OBIHL3 This device complies with FCC rules part 15. Operation is subject to the following conditions: 1- This device may not cause any harmful interference and 2- This device must accept any interference that may be received including interference that may cause undesired operation. The HomeLink system provides 3 buttons which can be individually selected and programmed using the transmitters for current, on-market devices as follows: 1. Press and hold the two outer HomeLink buttons (buttons one and three) ― releasing only when the indicator light begins to flash (after 20 seconds). Do not hold the buttons for longer than 30 seconds and do not repeat step 1 to program a second and/ or third hand-held transmitter to the remaining two HomeLink buttons. 2. Position the end of your hand-held transmitter 2.5―7.5 cm (1―3 inches) away from the HomeLink button you wish to program while keeping the indicator light in view. 3. Simultaneously press and hold both the chosen HomeLink and hand-held transmitter buttons. Do not release the buttons until step 4 has been completed. NOTE Some gate operators and garage door openers may require you to replace this Programming Step 3 with procedures noted in the "Gate Operator/Canadian Programming" section. NOTE The programming will not be erased even if the battery is disconnected. qPre-programming the HomeLink System NOTE It is recommended that a new battery be placed in the hand-held transmitter of the device being programmed to HomeLink for quicker training and accurate transmission of the radio-frequency signal. l l Verify that there is a remote control transmitter available for the device you would like to program. Disconnect the power to the device. qProgramming the HomeLink System CAUTION When programming a garage door opener or a gate, disconnect the power to these devices before performing programming, as continuous operation of the devices could damage the motor. 4. After the HomeLink indicator light changes from a slow to a rapidly blinking light, release both the HomeLink and hand-held transmitter buttons. NOTE If the HomeLink indicator light does not change to a rapidly blinking light, contact HomeLink at www.homelink.com or call 1800-355-3515 for assistance. 5-72

Section	Page
0. #Introduction#	1
#ZOOM-ZOOM#	1
#ZOOM-ZOOM#	1
A Word to Mazda Owners	3
#NO M-TITLE#	3
How to Use This Manual	4
#NO M-TITLE#	4
Table of Contents	5
1. Your Vehicle at a Glance	7
Interior Overview	8
Interior Equipment (View A)	8
Interior Equipment (View B)	9
Interior Equipment (View C)	10
Exterior Overview	11
Front	11
Rear	12
2. Essential Safety Equipment	13
Seats	14
Front Seats (Manually Operated Seats)	14
Front Seats (Electrically Operated Seats)	17
Second-Row Seats	22
Third-Row Seat	27
Head Restraints	28
Seat Warmer	29
Seat Belt Systems	31
Seat Belt Precautions	31
Front Seat Belt Pretensioner and Load Limiting Systems	37
Center-Rear Position Seat Belt (Second-Row Seats)	39
Seat Belt Extender	43
Seat Belt Warning Light/Beep	44
Child Restraint	46
Child Restraint Precautions	46
Installing Child-Restraint Systems	50
LATCH Child-Restraint Systems	57
SRS Air Bags	62
Supplemental Restraint System (SRS) Precautions	62
Supplemental Restraint System Components	67
How the SRS Air Bags Work	68
SRS Air Bag Deployment Criteria	72
Limitations to SRS Air Bag	73
Driver and Front Passenger Occupant Classification System	75
Monitoring and Maintenance	80
3. Knowing Your Mazda	83
Advanced Keyless Entry and Start System	84
Advanced Keys	84
Operation Using Advanced Keyless Functions	89
Operation Using Advanced Key Functions	95
Advanced Key Suspend Function	98
Warning and Beep Sounds	99
Setting Change (Function Customization)	101
When Warning Indicator/Beep is Activated	102
Doors and Locks	103
Keys	103
Keyless Entry System	104
Door Locks	109
Liftgate	112
Power Windows	119
Fuel-Filler Lid and Cap	126
Hood	128
Moonroof	129
Security System	132
Immobilizer System (with Advanced Key)	132
Immobilizer System (without Advanced Key)	135
Theft-Deterrent System	137
Steering Wheel and Mirrors	140
Steering Wheel	140
Mirrors	140
4. Before Driving Your Mazda	145
Fuel and Engine Exhaust Precautions	146
Fuel Requirements	146
Emission Control System	147
Engine Exhaust (Carbon Monoxide)	148
Before Starting the Engine	149
Before Getting In	149
After Getting In	149
Driving Tips	150
Break-In Period	150
Money-Saving Suggestions	150
Hazardous Driving	151
Floor Mat	153
Rocking the Vehicle	153
Winter Driving	154
Driving In Flooded Area	155
Overloading	156
Driving on Uneven Road	157
Towing	158
Trailer Towing (Except Mexico)	158
5. Driving Your Mazda	167
Starting and Driving	168
Ignition Switch	168
Starting the Engine	170
Brake System	171
Automatic Transaxle Controls	176
Power Steering	182
All-Wheel Drive (AWD) Operation	182
Cruise Control	185
Traction Control System (TCS)	188
Dynamic Stability Control (DSC)/Roll Stability Control (RSC)	191
Tire Pressure Monitoring System	193
Blind Spot Monitoring (BSM) System	199
Instrument Cluster and Indicators	204
Meters and Gauges	204
Warning/Indicator Lights and Beep Sounds	209
Warning/Indicator Lights	209
Beep Sounds	224
Switches and Controls	226
Lighting Control	226
Turn and Lane-Change Signals	229
Fog Lights	230
Windshield Wipers and Washer	230
Rear Window Wiper and Washer	234
Rear Window Defroster	235
Horn	236
Hazard Warning Flasher	236
HomeLink Wireless Control System	237
6. Interior Comfort	241
Climate Control System	242
Operating Tips	242
Vent Operation (Front)	244
Fully Automatic Type	246
Vent Operation (Rear)	252
Control Panel (Rear)	254
Audio System	257
Antenna	257
Operating Tips for Audio System	257
Audio Set	267
Audio Control Switch Operation (Steering Wheel)	298
AUX Mode (Auxiliary input)	301
Safety Certification	303
Rear Entertainment System	304
Rear Entertainment System	304
Part Names	313
Before Operation	316
Sound Output	322
Rear Entertainment System Functions	326
DVD video, DVD audio, Video CD, Audio CD and MP3/WMA CD Playback (Disc Mode)	327
Auxiliary Input (AUX mode)	341
Language Code List	345
Country Code List	347
Error Message	351
Symptoms and Actions	353
Bluetooth Hands-Free	356
Bluetooth Hands-Free	356
Basic Bluetooth Hands-Free Operation	360
Convenient Use of the Hands-Free System	363
Hands-Free Setting	369
When Bluetooth Hands-Free Cannot be Used	375
Safety Certification	376
Mazda Bluetooth Hands-Free Customer Service	376
Interior Equipment	377
Sunvisors	377
Interior Lights	378
Information Display	380
Cup Holder	384
Bottle Holder	386
Storage Compartments	386
Accessory Sockets	390
Power Outlet	391
7. In Case of an Emergency	393
Parking in an Emergency	394
Parking in an Emergency	394
Flat Tire	395
Spare Tire and Tool Storage	395
Changing a Flat Tire	400
Overheating	406
Overheating	406
Emergency Starting	408
Jump-Starting	408
Push-Starting	410
Emergency Towing	411
Towing Description	411
Tiedown Hooks	412
Recreational Towing	414
8. Maintenance and Care	415
Introduction	416
Introduction	416
Scheduled Maintenance	417
Scheduled Maintenance (USA, Canada, and Puerto Rico)	417
Scheduled Maintenance (Mexico)	423
Owner Maintenance	430
Owner Maintenance Schedule	430
Owner Maintenance Precautions	431
Engine Compartment Overview	432
Engine Oil	433
Engine Coolant	435
Brake Fluid	437
Power Steering Fluid	438
Automatic Transaxle Fluid (ATF)	438
Washer Fluid	440
Body Lubrication	441
Wiper Blades	441
Battery	445
Tires	447
Light Bulbs	451
Fuses	458
Appearance Care	466
How to Minimize Environmental Paint Damage	466
Exterior Care	468
Interior Care	471
9. Customer Information and Reporting Safety Defects	473
Customer Assistance	474
Customer Assistance (U.S.A.)	474
Customer Assistance (Canada)	477
Customer Assistance (Puerto Rico)	480
Customer Assistance (Mexico)	481
Mazda Importer/Distributors	483
Importer/Distributor	483
Distributor in Each Area	483
Warranty	485
Warranties for Your Mazda	485
Outside the United States and Canada	486
Outside the United States	487
Outside Canada	488
Registering Your Vehicle in A Foreign Country (Except United States and Canada)	489
Add-On Non-Genuine Parts and Accessories	490
Cell Phones	491
Cell Phones Warning	491
Type Approval of Equipment	492
Type Approval of Equipment (Mexico)	492
Uniform Tire Quality Grading System (UTQGS)	494
Uniform Tire Quality Grading System (UTQGS)	494
Tire Information (except Canada)	496
Tire Labeling	496
Location of the Tire Label (Placard)	502
Tire Maintenance	505
Vehicle Loading	508
Steps for Determining the Correct Load Limit:	515
Reporting Safety Defects	516
Reporting Safety Defects (U.S.A.)	516
Reporting Safety Defects (Canada)	517
Service Publications	518
Service Publications	518
10. #Specifications#	521
Identification Numbers	522
Vehicle Information Labels	522
Specifications	524
Specifications	524
11. #Index#	529
Index	530

Match case Limit results 1 per page

NOTE

FCC ID: NZLOBIHL3

CANADA:4112A-OBIHL3

This device complies with FCC rules part 15.

Operation is subject to the following

conditions:

1- This device may not cause any harmful

interference and

2- This device must accept any interference

that may be received including interference

that may cause undesired operation.

NOTE

The programming will not be erased even if

the battery is disconnected.

Pre-programming the HomeLink

System

NOTE

It is recommended that a new battery be

placed in the hand-held transmitter of the

device being programmed to HomeLink for

quicker training and accurate transmission of

the radio-frequency signal.

Verify that there is a remote control

transmitter available for the device you

would like to program.

Disconnect the power to the device.

Programming the HomeLink System

CAUTION

When programming a garage door

opener or a gate, disconnect the

power to these devices before

performing programming, as

continuous operation of the devices

could damage the motor.

The HomeLink system provides 3 buttons

which can be individually selected and

programmed using the transmitters for

current, on-market devices as follows:

1. Press and hold the two outer

HomeLink buttons (buttons one and

three)

―

releasing only when the

indicator light begins to flash (after 20

seconds).

Do not

hold the buttons for

longer than 30 seconds and

do not

repeat step 1

to program a second and/

or third hand-held transmitter to the

remaining two HomeLink buttons.

2. Position the end of your hand-held

transmitter 2.5

―

7.5 cm (1

―

3 inches)

away from the HomeLink button you

wish to program while keeping the

indicator light in view.

3. Simultaneously press and hold both the

chosen HomeLink and hand-held

transmitter buttons.

Do not release the

buttons until step 4 has been

completed.

NOTE

Some gate operators and garage door openers

may require you to replace this Programming

Step 3 with procedures noted in the

“

Gate

Operator/Canadian Programming

”

section.

4. After the HomeLink indicator light

changes from a slow to a rapidly

blinking light, release both the

HomeLink and hand-held transmitter

buttons.

NOTE

If the HomeLink indicator light does not

change to a rapidly blinking light, contact

HomeLink at

www.homelink.com

or call

800-355-3515

for assistance.

5-72

Driving Your Mazda

Switches and Controls