2009 Mazda CX-9 Owner's Manual - Page 285
2009 Mazda CX-9 Manual
Page 285 highlights
Interior Comfort Audio System 4. Input the registered ID code using channel preset buttons 1-4. Then press the scan button. Example: When the registered ID code is "2323", input "2323". At this time "SR1 2323" is displayed. Press 1 for the first digit, 2 for the second, 3 for the third, and 4 for the last digit. For example, if your number is 2323, press 1 three times, 2 four times, 3 three, and 4 four times. If the display goes off while inputting, begin from Step 1. NOTE The registered ID code is the default [0000] at the time of factory shipment. If [0000] results in "Err" on the display, go to the "INITIALIZATION OF ID CODE" section to reset to [0000]. (New ID code input determination) 10. Determine the new ID code which has been input by pressing the scan button. 11. "PIN CHANGED" appears for 3 seconds which indicates that the new ID code input has been completed. 12. It returns to the former display. (How to clear the message) l Press any of the following FM/AM, SAT, CD, AUX, CAT, ESN/DISP, Instant replay, POWER buttons. l Turn the ACC off or insert a CD. NOTE l (Verification with the registered ID code) 5. Determine the input code by pressing the scan button. 6. If it does not match with the previously registered code, "SR1 Err" is displayed and then it returns to "SR1 7. If it matches with the previously registered code, "ENTER PIN" appears again and it switches to code input mode. 8. "SR1 - - - -" appears, and it is ready for input of the new ID code. (New ID code input) 9. Input the new ID code using channel preset buttons 1-4. Example: If "1234" is input as the new code, "SR1 1234" is displayed. Press the scan button after the code is input. l If an ID code is not input for 10 seconds, "Err" is displayed and it returns to the former display. Channel preset buttons 1, 2, 3, 4 and the scan button are used for input of the ID code. Buttons 5 and 6 cannot be used. Individual channel locking If a channel is locked, the channel is muted. NOTE If the registered ID code is forgotten, return the ID code to the default [0000]. (See "INTIALIZATION OF ID CODE" section) (Locking a channel) 1. Select a channel to be locked by turning the manual tuning dial. Example: Select channel 100 (Registered ID code input preparation) 2. Hold the scan button, then press channel preset button 6, hold both buttons together for 1.5 seconds. 6-45