2009 Mazda CX-9 Owner's Manual - Page 286
2009 Mazda CX-9 Manual
Page 286 highlights
Interior Comfort Audio System 3. "ENTER PIN" appears for 2 seconds which indicates that it is in code input mode. 4. "SR1 - - - -" appears which indicates that it is ready for code input. (Registered ID code input) 5. Input the registered ID code using channel preset buttons 1-4. Example: If the registered ID code is "2323", input "2323". At this time "SR1 2323" is displayed. Press the scan button after the code is input. (Registered ID code input determination) 6. Determine the code which has been input by pressing the scan button. 7. If it does not match the registered code, "SR1 Err" is displayed and then it returns to "SR1 8. If it matches the registered code, "SR1 LOCK" appears for 3 seconds which indicates that the code input has been completed. 9. "SR1 LOCK 100" appears which indicates that the parental lock is activated. At this time, mute is on and no sound is heard. (How to clear the message) l Press any of the following FM/AM, SAT, CD, AUX, CAT, ESN/DISP, Instant replay, POWER buttons. l Turn the ACC off or insert a CD. NOTE l Lock cancellation Setting condition: SAT mode (Releasing a locked channel) 1. Select a channel to be released by turning the manual tuning dial. Example: Select the locked channel (i.e. 100). At this time, "SR1 LOCK 100" is displayed. (Registered ID code input preparation) 2. Hold the scan button, then press channel preset button 6, hold both buttons together for 1.5 seconds. 3. "ENTER PIN" appears for 2 seconds which indicates that it is in code input mode. 4. "SR1 - - - -" appears, which indicates that it is ready for code input. (Registered ID code input) 5. Input the registered ID code using channel preset buttons 1-4. Example: When the registered ID code is "2323", input "2323". At this time "SR1 2323" is displayed. Press the scan button after the code is input. NOTE If "Err" is displayed, go to the "INITIALIZATION OF ID CODE" section to reset the ID code to [0000]. (Registered ID code input determination) 6. Determine the input code by pressing the scan button. 7. If it does not match the registered code, "SR1 Err" is displayed and then it returns to "SR1 - - - -". l If an ID code is not input for 10 seconds, "Err" is displayed and it returns to the former display. Channel preset buttons 1, 2, 3, 4 and the scan button are used for input of the ID code. Buttons 5 and 6 cannot be used. 6-46