2012 Nissan Murano Owner's Manual - Page 103
2012 Nissan Murano Manual
Page 103 highlights
. If the light illuminates while driving, avoid sudden steering maneuvers or abrupt braking, reduce vehicle speed, pull off the road to a safe location and stop the vehicle as soon as possible. Driving with under-inflated tires may permanently damage the tires and increase the likelihood of tire failure. Serious vehicle damage could occur and may lead to an accident and could result in serious personal injury. Check the tire pressure for all four tires. Adjust the tire pressure to the recommended COLD tire pressure shown on the Tire and Loading Information label to turn the low tire pressure warning light OFF. If the light still illuminates while driving after adjusting the tire pressure, a tire may be flat. If you have a flat tire, replace it with a spare tire as soon as possible. When a spare tire is mounted or a wheel is replaced, the TPMS will not function and the low tire pressure warning light will flash for approximately 1 minute. The light will remain on after 1 minute. Contact your NISSAN dealer as soon as possible for tire replacement and/ or system resetting. . Replacing tires with those not originally specified by NISSAN could affect the proper operation of the TPMS. ... CAUTION . The TPMS is not a substitute for the regular tire pressure check. Be sure to check the tire pressure regularly. If the vehicle is being driven at speeds of less than 16 MPH (25 km/h), the TPMS may not operate correctly. Be sure to correctly install the specified size of tires to the four wheels. No key warning Low fuel warning Low washer fluid warning Parking brake release warning Door/lift gate open warning (Hardtop models) . Door/trunk open warning (CrossCabriolet models) . Loose fuel cap warning . Check tire pressure warning See "Dot matrix liquid crystal display" later in this section. . Seat belt warning light GUID-956FC59D-0351-472F-8CD0-3356E0A21318 The light and chime remind you to fasten seat belts. The light illuminates whenever the ignition switch is pushed to the ON position, and will remain illuminated until the driver's seat belt is fastened. The seat belt warning light for the front passenger will illuminate if the seat belt is not fastened when the front passenger's seat is occupied. For approximately 5 seconds after the ignition switch is in the ON position, the system does not activate the warning light for the front passenger. See "Seat belts" in the "1. Safety - Seats, seat belts and supplemental restraint system" section for precautions on seat belt usage. Instruments and controls 2-15 . . MasterGUID-6AB3A8A0-B446-4089-A66C-618A6659F580 warning light When the ignition switch is in the ON position, the master warning light illuminates if any of the following are displayed on the dot matrix liquid crystal display: