2012 Nissan Murano Owner's Manual - Page 256
2012 Nissan Murano Manual
Page 256 highlights
Adjusting sound quality: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 Push the Audio control knob to change the selecting mode as follows. Bass ? Treble ? Fade ? Balance ? Speed Sensitive Volume ? Beep Rotate the Audio control knob to adjust Bass, Treble, Fade and Balance to the desired level. Fade adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. These items can also be adjusted by pushing the AUDIO button. . Speed Sensitive Vol. Sound volume is increased according to the vehicle speed. Choose the effect level from "HIGH", "MID", "LOW" or "OFF". . Beep tuning When this item is turned to ON, you will hear a beep sound when you use a button. Once you have adjusted the sound quality to the desired level, push the Audio control knob repeatedly until the radio or CD display reappears. Otherwise, the radio or CD display will automatically reappear after about 5 seconds. CLOCK adjust: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 Push the CLOCK adjust button for more than 1.5 seconds to turn on the CLOCK display. 9 for 1. Push and hold the CLOCK button * more than 2 seconds until the display shows "Hour Adjust". on when the ON·OFF/VOL control knob is pushed to ON. If another audio source is playing when the radio band select button is turned to ON, the audio source will automatically be turned off and the last radio station played will come on. When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception. TUNE (Tuning): GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 Turn the TUNE/FOLDER knob for manual tuning. SEEK tuning: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 Push the SEEK·CAT or TRACK button or to tune from low to high or high to low frequencies and to stop at the next broadcasting station. SCAN tuning: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 Push the SCAN tuning button to tune from low to high frequencies and stops at each broadcasting station for 5 seconds. Pushing the button again during this 5 seconds period will stop SCAN tuning and the radio will remain tuned to that station. If the SCAN tuning button is not pushed within 5 seconds, SCAN tuning moves to the next station. 2. Turn the AUDIO knob 4 * to adjust hours. 9 3. Push the CLOCK button * or AUDIO 2 knob * to enter. The display will show "Minute Adjust". 4 to adjust minutes. 4. Turn the AUDIO knob * 9 * 5. Push the CLOCK button 4 to enter. knob * or AUDIO The display will return to the regular clock display after 10 seconds. If the power supply is disconnected, the clock will not indicate the correct time. Readjust the time. AM-FM radio operation GUID-1376C7D0-99F6-4FBC-8CC2-16FA35A11F12 radio (FM/AM) band select: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 Pushing the radio band select button will change the band as follows: AM ? FM1 ? FM2 ? AM When the radio band select button is pushed while the ignition switch is in the ACC or ON position, the radio will come on at the station last played. The last station/channel played will also come 4-50 Monitor, heater, air conditioner, audio, phone and voice recognition systems