2012 Nissan Murano Owner's Manual - Page 146
2012 Nissan Murano Manual
Page 146 highlights
operation, push the moonroof switch to either of 1 , CLOSE * 2 or UP * 5 position. the OPEN * Tilting moonroof GUID-5BCB6B6D-1017-4E94-B105-E837913634C6 To tilt up the moonroof, push the moonroof 5 . switch to the UP position * To tilt down the moonroof, push the switch to the 5 UP position * or push the switch to the 2 . CLOSE position * When the moonroof is tilted up, push the moonroof switch to the second detent to the 4 . The moonroof will tilt down CLOSE position * and the sunshades will close. The auto reverse function can be activated when the moonroof and sunshades are closed by automatic operation when the ignition switch is in the ON position or for about 45 seconds after the ignition switch is pushed to the OFF position. If the moonroof and sunshades cannot be closed automatically when the auto reverse function activates due to a malfunction, push 2 . and hold the switch to the CLOSE position * Depending on the environment or driving conditions, the auto reverse function may be activated if an impact or load similar to something being caught in the moonroof occurs. SIC3801 Sliding sunshade and moonroof GUID-35ECC1C1-78E5-4B3C-860F-E718E2CD552D When the moonroof switch is pushed to the 1 , the front and rear sunOPEN position * shades will fully open. When the switch is pushed again, the moonroof will fully open. When the moonroof switch is pushed to the 2 , the moonroof will autoCLOSE position * matically close. Push the switch again, and the front and rear sunshades will close. When the moonroof switch is pushed to the 3 or CLOSE * 4 second detent to the OPEN * position, both the sunshade and moonroof will open or close. To stop the sunshades or moonroof during the Auto reverse GUID-07736A6E-057D-4405-B60A-86505A7F3C58 function WARNING There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the moonroof. If the control unit detects something caught in the moonroof and sunshades when they are closing, the moonroof will be immediately opened. If the moonroof does not operate GUID-55D929EA-1A05-47B0-9DBB-75466D80DB38 If the moonroof does not operate properly, perform the following procedure to initialize the moonroof operation system. 1. If the moonroof is open, close it fully by pushing the switch to the CLOSE position 2 . * 2. Push and hold the switch to the CLOSE 2 . position * 3. Release the moonroof switch after the moonroof or sunshade moves slightly to the closed position. 2-58 Instruments and controls