2012 Nissan Murano Owner's Manual - Page 353
2012 Nissan Murano Manual
Page 353 highlights
BEFORE STARTING THE ENGINE GUID-147FB3A5-0560-4EED-8FD9-82CD1174F15F STARTING THE ENGINE GUID-F37FF9D7-0BFA-4B95-99B8-BFD3E3B48784 the Intelligent Key out of the port. NOTE: The key port does not charge the key battery. If you see the low battery indicator in the dot matrix liquid crystal display, replace the battery as soon as possible. (See "Intelligent key battery replacement" in the "8. Maintenance and do-it-yourself" section.) . . . . CAUTION . Never place anything except the Intelligent Key in the key port. Doing so may cause damage to the equipment. Make sure the Intelligent Key is in the correct direction when inserting it to the key port. The engine may not start if it is in the incorrect direction. Remove the Intelligent Key from the key port after the ignition switch is pushed to the OFF position. ... . Make sure the area around the vehicle is clear. Check fluid levels such as engine oil, coolant, brake fluid and window washer fluid as frequently as possible, or at least whenever you refuel. Check that all windows and lights are clean. Visually inspect tires for their appearance and condition. Also check tires for proper inflation. Lock all doors. Position seats and adjust head restraints/ headrests. Adjust inside and outside mirrors. Fasten seat belts and ask all passengers to do likewise. Check the operation of warning lights when the ignition switch is pushed to the ON position. (See "Warning/indicator lights and audible reminders" in the "2. Instruments and controls" section.) 1. Apply the parking brake. 2. Move the selector lever to the P (Park) or N (Neutral) position. (P is recommended.) The starter is designed not to operate unless the selector lever is in either of the above positions. 3. Push the ignition switch to the ON position. Depress the brake pedal and push the ignition switch to start the engine. To start the engine immediately, push and release the ignition switch while depressing the brake pedal with the ignition switch in any position. . If the engine is very hard to start in extremely cold weather or when restarting, depress the accelerator pedal a little (approximately 1/3 to the floor) and while holding, crank the engine. Release the accelerator pedal when the engine starts. . If the engine is very hard to start because it is flooded, depress the accelerator pedal all the way to the floor and hold it. Push the ignition switch to the ON position to start cranking the engine. After 5 or 6 seconds, stop cranking by pushing the ignition switch to OFF. After cranking the engine, release the accelerator pedal. Crank the engine with your foot off the accelerator pedal by Starting and driving 5-13 .