2012 Nissan Murano Owner's Manual - Page 301

Bluetooth® HANDS-FREE PHONE SYSTEM (models without navigation system) (if so equipped) GUID-2E3BF6A6-4523-4285-8F92-0F4C9B6526E1 WARNING . Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be given to vehicle operation. If you find yourself unable to devote full attention to vehicle operation while talking on the phone, pull off the road to a safe location and stop your vehicle before doing so. Once your cellular phone is paired to the invehicle phone module, no phone connecting procedure is required. Your phone is automatically connected with the in-vehicle phone module when the ignition switch is pushed to the "ON" position with the registered cellular phone turned on and carried in the vehicle. You can register up to 5 different Bluetooth® cellular phones in the in-vehicle phone module. However, you can talk on only one cellular phone at a time. When a call is active, the audio system and microphone (located in the ceiling in front of the rearview mirror) are used for the handsfree communications. If the audio system is being used at the time, the audio mode will mute and will stay muted until the active call is ended. The NISSAN Voice Recognition system supports the phone commands, so dialing a phone number using your voice is possible. Before using the Bluetooth® Hands-Free Phone System, refer to the following notes. . Wireless LAN (Wi-Fi) and the Bluetooth® functions share the same frequency band (2.4 GHz). Using the Bluetooth® and the wireless LAN functions at the same time may slow down or disconnect the communication and cause undesired noise. It is . . . . CAUTION To avoid draining the vehicle battery, use a phone after starting the engine. Your vehicle is equipped with Bluetooth ® Hands-Free Phone System. If you are an owner of a Bluetooth® enabled cellular phone, you can set up the wireless connection between your cellular phone and the in-vehicle phone module. With Bluetooth® wireless technology, you can make or receive a telephone call with your cellular phone in your pocket. . . recommended that you turn off the wireless LAN (Wi-Fi) when using the Bluetooth® functions. Set up the wireless connection between a cellular phone and the in-vehicle phone module before using the Bluetooth ® Hands-Free Phone System. Some Bluetooth® enabled cellular phones may not be recognized by the in-vehicle phone module. You will not be able to use a hands-free phone under the following conditions: - Your vehicle is outside of the telephone service area. - Your vehicle is in an area where it is difficult to receive radio waves; such as in a tunnel, in an underground parking garage, behind a tall building or in a mountainous area. - Your cellular phone is locked in order not to be dialed. When the radio wave condition is not ideal or ambient sound is too loud, it may be difficult to hear the other person's voice during a call. Immediately after the ignition switch is pushed to the "ON" position, it may be impossible to receive a call for a short period of time. Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-95