2012 Nissan Murano Owner's Manual - Page 354
2012 Nissan Murano Manual
Page 354 highlights
DRIVING THE VEHICLE depressing the brake pedal and pushing the push-button ignition switch to start the engine. If the engine starts, but fails to run, repeat the above procedure. GUID-874DAAA4-503F-461F-8A66-BEEC6486BBB0 CONTINUOUSLY VARIABLE TRANSMISSION (CVT) GUID-ACCD68EB-D536-48ED-BBB3-82DB1D8F06BA The Continuously Variable Transmission (CVT) in your vehicle is electronically controlled to produce maximum power and smooth operation. The recommended operating procedures for this transmission are shown on the following pages. Follow these procedures for maximum vehicle performance and driving enjoyment. Engine power may be automatically reduced to protect the CVT if the engine speed increases quickly when driving on slippery roads or while being tested on some dynamometers. 2. Keep the foot brake pedal depressed and move the selector lever to a driving position. 3. Release the parking brake and foot brake pedal, and then gradually start the vehicle in motion. CAUTION Do not operate the starter for more than 15 seconds at a time. If the engine does not start, push the ignition switch to OFF and wait 10 seconds before cranking again, otherwise the starter could be damaged. 4. Warm-up Allow the engine to idle for at least 30 seconds after starting. Do not race the engine while warming it up. Drive at moderate speed for a short distance first, especially in cold weather. In cold weather, keep the engine running for a minimum of 2 3 minutes before shutting it off. Starting and stopping the engine over a short period of time may make the vehicle more difficult to start. 5. To stop the engine, shift the selector lever to the P (Park) position and push the ignition switch to the OFF position. WARNING . Do not depress the accelerator pedal while shifting from P (Park) or N (Neutral) to R (Reverse), D (Drive) or L (Low) position. Always depress the brake pedal until shifting is completed. Failure to do so could cause you to lose control and have an accident. Cold engine idle speed is high, so use caution when shifting into a forward or reverse gear before the engine has warmed up. Never shift to P (Park) or R (Reverse) while vehicle is moving. Failure to do so could cause you to lose control and have an accident. Starting the vehicle GUID-35972EF7-F09E-4D7E-99A4-08117777767B 1. After starting the engine, fully depress the foot brake pedal before moving the selector lever out of the P (Park) position. This CVT is designed so that the foot brake pedal must be depressed before shifting from P (Park) to any driving position while the ignition switch is in the ON position. The selector lever cannot be moved out of the P (Park) position and into any of the other positions if the ignition switch is pushed to the LOCK, OFF or ACC position. . . 5-14 Starting and driving