2012 Nissan Murano Owner's Manual - Page 383

SCE0869 SCE0870 A of the hose 5. Remove the protective cap * and screw the hose securely onto the tire valve. Make sure that the pressure release B is securely tightened. Make sure valve * that the air compressor switch is in the OFF (*) position, and then insert its power plug into the power outlet in the vehicle. SCE0871 3. Remove the cap from the tire sealant bottle, and screw the bottle clockwise onto the bottle holder. (Leave the bottle seal intact. Screwing the bottle onto the bottle holder will pierce the seal of the bottle.) 4. Remove the cap from the tire valve on the flat tire. 6. Push the ignition switch to the "ACC" position. Then turn the compressor switch to the ON (−) position and inflate the tire up to the pressure that is specified on the tire and loading information label affixed to the driver's side center pillar if possible, or to the minimum of 180 kPa (26 psi). Turn the air compressor off briefly in order to check the tire pressure with the pressure gauge. If the tire is inflated to higher than the specified pressure, lower the tire pressure by releasing air with the pressure release valve. In case of emergency 6-13