2012 Nissan Murano Owner's Manual - Page 303
2012 Nissan Murano Manual
Page 303 highlights
VOICE RECOGNITION SYSTEM GUID-9B7C908B-6C37-4AF6-881B-ED74B9733676 INFO . The available voice commands are only applicable to the relevant language set in the LANGUAGE setting screen. (See "How to use SETTING button" earlier in this section.) If the vehicle is in motion, some commands may not be available so full attention may be given to vehicle operation. The voice recognition system cannot be operated when the soft top (CrossCabriolet models) is open. You can also use the Bluetooth® hands-free phone system with Voice Recognition System. Using system GUID-971AC84E-9C3B-4FD1-B89A-CAAB5B8FF18C Initialization: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 When the ignition switch is pushed to the ON position, Voice Recognition System is initialized, which may take up to one minute. When completed, the system is ready to accept voice commands. If the switch on the steering wheel is pushed before the initialization completes, the system will not accept any command. Before starting: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 To get the best performance out of the Voice Recognition System, observe the following: . Keep the interior of the vehicle as quiet as possible. Close the windows to eliminate the surrounding noises (traffic noises, vibration sounds, etc.), which may prevent the system from recognizing the voice commands correctly. Wait until a tone sounds before speaking a command. Speak a voice command within 5 seconds after the beep sound. If no voice command is given, the system will ask you for a number. If no further command is given, the session ends. Speak in a natural voice without pausing between words. . SAA1858 . CONTROL BUTTONS GUID-97C1E7DF-2E99-4A06-9A42-9D6CE21376A6 1. PHONE SEND button Push the button to initiate a VR session or answer an incoming call. You can also use the button to skip through system feedback and to enter commands during a call. 2. PHONE END button Push the button to cancel a VR session or end a call. Manual command selection GUID-7A9C0620-4464-41D4-A48F-87414C8E0577 Commands can be selected manually. While the commands are displayed on the screen, select a command by operating the Tune switch, and then push the PHONE SEND button. Once a command is manually selected, the voice command function is cancelled. To return to voice command mode, push the PHONE END button to cancel the current operation, and then perform the first procedure of voice command... . Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-97