2012 Nissan Murano Owner's Manual - Page 105
2012 Nissan Murano Manual
Page 105 highlights
CruiseGUID-C4011DB6-8909-4DF3-8C75-17ED51FCED58 indicator light Cruise main switch indicator: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 This light illuminates when the cruise control main switch is pushed. The light turns off when the main switch is pushed again. When the cruise main switch indicator light illuminates, the cruise control system is operational. (See "Cruise control" in the "5. Starting and driving" section.) Cruise malfunction: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 If the cruise indicator light blinks while the engine is running, it may indicate the cruise control system is not functioning properly. Have the system checked by a NISSAN dealer. (See "Cruise control" in the "5. Starting and driving" section.) High beam indicator light GUID-4EECC9D2-4C62-4418-9FA3-CF0C228A1386 This light comes on when the headlight high beam is on and goes out when the low beam is selected. tion/Maintenance (I/M) test" in the "9. Technical and consumer information" section.) Operation: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 The malfunction indicator light will come on in one of two ways: . Malfunction indicator light on steady - An emission control system and/or CVT malfunction has been detected. Check the fuelfiller cap if the LOOSE FUEL CAP warning appears on the dot matrix liquid crystal display. If the fuel-filler cap is loose or missing, tighten or install the cap and continue to drive the vehicle. The light should turn off after a few driving trips. If the light does not turn off after a few driving trips, have the vehicle inspected by a NISSAN dealer. You do not need to have your vehicle towed to the dealer. Malfunction indicator light blinking - An engine misfire has been detected which may damage the emission control system. To reduce or avoid emission control system damage: - Do not drive at speeds above 45 MPH (72 km/h). - Avoid hard acceleration or deceleration. - Avoid steep uphill grades. Low beam indicator light GUID-31C3710D-82FC-41EC-AE8C-69D56A05CEF7 The light comes on when the front park, side marker, tail and license plate lights are on. Malfunction Indicator Light (MIL) GUID-6AF8662E-1DE1-45FE-852C-925D132DCE37 If the malfunction indicator light comes on steady or blinks while the engine is running, it may indicate a potential emission control and/or Continuously Variable Transmission (CVT) malfunction. The malfunction indicator light may also come on steady if the fuel-filler cap is loose or missing, or if the vehicle runs out of fuel. Check to make sure the fuel-filler cap is installed and closed tightly, and that the vehicle has at least 3 US gallons (11.4 liters) of fuel in the fuel tank. After a few driving trips, the light should turn off if no other potential emission control system malfunction exists. If this indicator light remains on for 20 seconds and then blinks for 10 seconds when the engine is not running, it indicates that the vehicle is not ready for an emission control system inspection/ maintenance test. (See "Readiness for Inspec- Front passenger air bag status light GUID-1AD6EFB7-D318-4868-99B0-D18664F33C71 The front passenger air bag status light will be lit and the passenger front air bag will be OFF depending on how the front passenger seat is being used. For front passenger air bag status light operation, see "NISSAN Advanced Air Bag System (front seats)" in the "1. Safety - Seats, seat belts and supplemental restraint system" section of this manual. . Instruments and controls 2-17