2012 Nissan Murano Owner's Manual - Page 379
2012 Nissan Murano Manual
Page 379 highlights
than 2 times, until they are tight. 4. Lower the vehicle slowly until the tire touches the ground. Then, with the wheel nut wrench, tighten the wheel nuts securely in the sequence as illustrated. Lower the vehicle completely. . is recommended that wheel nuts be tightened to specifications at each lubrication interval. Adjust tire pressure to the COLD pressure. COLD pressure: After the vehicle has been parked for three hours or more or driven less than 1 mile (1.6 km). COLD tire pressures are shown on the Tire and Loading Information label affixed to the driver side center pillar. accident or sudden stop. . The T-type spare tire and small size spare tire are designed for emergency use. See specific instructions under the heading "Wheels and tires" in the "8. Maintenance and do-it-yourself" section. WARNING . Incorrect wheel nuts or improperly tightened wheel nuts can cause the wheel to become loose or come off. This could cause an accident. Do not use oil or grease on the wheel studs or nuts. This could cause the nuts to become loose. Retighten the wheel nuts when the vehicle has been driven for 600 miles (1,000 km) (also in cases of a flat tire, etc.). . REPAIRING FLAT TIRE (CrossCabriolet models) GUID-D9962E43-FAC1-47B3-95F5-3D1669BC7013 WARNING . After using Emergency Tire Sealant to repair a minor tire puncture, do not drive the vehicle at speeds faster than 50 MPH (80 km/h). Immediately after using the Emergency Tire Sealant to repair a minor tire puncture, take your vehicle to a NISSAN dealer to inspect, and repair or replace the tire. The Emergency Tire Sealant cannot permanently seal a punctured tire. Continuing operation of the vehicle without a permanent tire repair can lead to a crash. . Stowing the damaged tire and the tools GUID-5F970DF2-6B95-4075-80AB-901E39A1729F 1. Securely store the damaged tire, jack and tools in the storage area. 2. Replace the cargo box. 3. Close the cargo floor board. 4. Close the lift gate. . . As soon as possible, tighten the wheel nuts to the specified torque with a torque wrench. Wheel nut tightening torque: 80 ft-lb (108 N·m) The wheel nuts must be kept tightened to specification at all times. It WARNING . Always make sure that the spare tire and jacking equipment are properly secured after use. Such items can become dangerous projectiles in an In case of emergency 6-9