2012 Nissan Murano Owner's Manual - Page 144

Automatic operation GUID-3B0158AA-9687-4021-B3A8-12225F5D2198 The automatic function is available for the switch that has an mark on its surface. To fully open or close the window, completely push down or pull up the switch and release it; it need not be held. The window will automatically open or close all the way. To stop the window, just push or lift the switch in the opposite direction. A light push or pull on the switch will cause the window to open or close until the switch is released. The rear window automatic operation is for the opening function only (CrossCabriolet models). Auto reverse GUID-19580295-1D80-4877-93A6-203373FD0AB2 function Automatic window lowering (CrossCabriolet models) GUID-68431D2A-45C1-4082-9602-DC8E37328739 When the soft top operating switch is pressed, the power windows will automatically be lowered completely. The windows do not rise automatically after the soft top open/close operation is completed. Use the power window switches to raise them. WARNING There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the window. If the control unit detects something caught in the window as it is closing, the window will be immediately lowered. The auto reverse function can be activated when the window is closed by automatic operation when the ignition switch is in the ON position or for 45 seconds after the ignition switch is pushed to the OFF position. Depending on the environment or driving conditions, the auto reverse function may be activated if an impact or load similar to something being caught in the window occurs. Automatic adjusting function (CrossCabriolet models) GUID-2A57D8B8-D2B5-4017-A2B4-5D5758878B3A CAUTION When the battery cable is removed from the battery terminal, do not close either of the front doors. The automatic window adjusting function will not work and the side roof panel may be damaged. The power window has an automatic adjusting function. When the door is being opened, the window is automatically lowered slightly to avoid contact between the window and the top side rail. When the door is closed, the window is automatically raised slightly. While the automatic adjusting function does not work, the window will be controlled as follows: Simultaneous operation of all four windows (CrossCabriolet models) GUID-F3222C8C-2BD6-4165-85A5-6DEB6C706AF6 WARNING Make sure that all passengers have their hands, etc. inside the vehicle before closing the windows. When the driver's and passenger's door window switches (driver's side) are pushed down or pulled up simultaneously, all four windows are opened or closed. 2-56 Instruments and controls