Brother International BAS-760 Instruction Manual - English - Page 15
Thread, tension
View all Brother International BAS-760 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
LI Thread tension Stitches when upper thread s.. tension is too low Low High Stitches when upper thread tension is too high Correct stitches 1. When the thread take-up lever is in the highest position after thread trimming, adjust the upper thread beyond the needle eye so as it is 35 to 40 mm long, by turning tension nut 0. 2. Adjust the lower thread tension by turning tension regulating screw®. 3. Adjust the upper thread tension by turning tension nut @ and 0 after lowering the presser foot. X Then adjust the tension 30 - 40 g by turning tension nut 0. Main adjust is performed by using tension nut es. * Thread take-up spring 6 5mm 5mm 50- 60 g 1. The standard thread take-up spring height is 5 mm from the lower end of the thread guide. The standard thread take-up spring force is 50 to 60 g. 2. To adjust the thread take-up spring height, loosen set-screw 0 and turn the whole unit of the tension regulator assembly. 3. To adjust the thread take-up spring force, insert a screwdriver tip into the groove of tension stud fa and turn it as much as is appropriate. -12-