Brother International BAS-760 Instruction Manual - English - Page 39
©-©
View all Brother International BAS-760 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Next, add the speed reduction mode. 0 620 0 r 630 J r 444 J [1] (14) Read the program that is completed up to step €1. Input "999" H to continue moving the needles to the points below. When they reach the desired position, press the W and H keys to stop the feed operation. If the sewing clamp assembly moves too far and you wish to move it back, input "999" H, and press either the H or E key to stop the sewing clamp assembly in the desired position. (15) Move the needles to © and © points and input "630" EL The three needles which center on and © points will change to 3000 spm. This is to give stable sewing at the corners where speed decreases. a ® (16) Move the needles to and points and input "444" L. The Y feed timing of the needles at points and will become faster. ©-© O- (17) Move the needles to between and input '620" for each of the 5 needles. The speed between ® will change to 2,000 spm. Note: The speeds in steps (14) and after are intended to provide stable sewing quality, and are not necessarily improvements. Because they vary depending on the shape of the sewing pattern and also have an effect on cycle time, they can be set to any desired values. [Example 2] The program as shown in the illustration below will be created. If this example is used as a reference when programming, problems with lifting of the bobbin thread, incorrect cutting of the needle thread and uneven needle distribution on corners in the needle down position can be avoided. (With no bar tacking) (With bar tacking) 0.1 P/2 0.1SO 1 2.0 620E 0.1 0.1 0. 0.1 0 1 0.1 P P/2 P/2 P P/2 P/2 P 0.1 © 0.1 1 ©0.1 0.1 p 630O (3,000spm)I (630E) 620E] (2,000spm) 630L (3,000spm) 625El (2,500spm) 0.1 0.1 630E (630E) (3,000spm) 620E (2,000spm) 630E (3,000spm) 0.1 0.1 P/2 P/2 P/2 P/2 625O (2,500spm) -36-