Brother International BAS-760 Instruction Manual - English - Page 17
connection
View all Brother International BAS-760 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Alarm code U51 Error message Needle-bar drop - Turn the machine pulley to raise the needle-bar Alarm code U82 Error message No air pressure or air zipper has been turned off U52 Upper thread breakage- Pass the upper thread U83 X-right over-travel switch has been operated U53 Discrepancy between the folder and the program U54 Machine synchronism sensor wire break or malfunction U84 X-left over-travel switch has been operated U85 Y-above over-travel switch has been operated U55 Needle lift sensor U86 Y-under over-travel switch has been operated U56 Presser foot cylinder malfunction or sensor wire break U58 Needle zigzag cylinder malfunction or sensor wire break U87 X-axis motor system fault U88 Y-axis motor system fault U60 No data -) Check the floppy disk U89 Machine motor system fault U61 Sensor connector connection check alarm U90 Folder fault U62 Pattern number check alarm U91 X-axis positioning error U70 Try again -* Floppy disk fault U92 Y-axis positioning error U71 No data available from designated program U72 No disk in the FDD U73 Write protected --)Change the disk window U93 Over-area during programming operation U94 X-origin switch fault, or the X origin switch has been turned on when the power switch was turned on U95 Y origin switch fault or the Y origin switch has been turned on when the power switch was turned on U74 Designated number unavailable U96 X origin switch has been turned on U78 Keyword error U97 Sewing clamp malfunction U80 Emergency stop button has been pressed . U99 Bobbin change on-going is being displayed [Setting of the folding group assembly number and the program number] 70'75Lilt PROGRAM NO. FLOPPY (1) Check the folding group assembly number. (2) Input the number of sewing clamp assembly @ with PROGRAM No. switch 413. (3) Press FLOPPY button G. (4) At the end of floppy disk reading, the ALARM CODE/PIECE COUNTER will display the program number. (5) Check if the number of sewing clamp assembly e is identical to the displayed number. X If it is not, repeat procedures (2) to (4). X If you try to sew with discrepant numbers, "U53" will be displayed and the machine operation will be interrupted. 6B 3 Is! 1 -14-