Brother International BAS-760 Instruction Manual - English - Page 21

[Label attachment: Select LABEL] 1. Set the MODE switch 0 to LABEL. 2. Press the STACKER button so that the lamp illuminates. 3. Place the main material @ under the center blade assembly 0. 4. Depress the right foot switch ®. The main material will be clamped. 5. Place the pocket material ® over the center blade assembly 0. 6. Depress the right foot switch @ once more and keep it pressed down. e The inner clamp assembly will cover the top of the center blade assembly 0, and label setting will be possible. Set the label 0 in the clamp section @ of the label attachment device. After setting the label 0, release the right foot switch ®. Clamp the label ® in the clamp section ® and turn the label attachment device to the folding position. (If you wish to re-clamp the label depress the right foot switch 0 and keep it pressed down. The label can then be reset.) 7. Depress the left foot switch ® The pocket material 0 will be folded by the folder assembly. After the presser oot assembly has moved, the main material and the pocket material 0 are carried to the machine and sewing starts. 8. After sewing is completed, the machine will return to the standby condition. 0 MODE 0 ALU02 MANUAL AUTOI LABEL 2.7 v7 STEP STACKERON OFF FOLDER RESET \ N e X If the STEP switch is pressed at the same time as the FOLDER RESET ® button is being pressed, the mode can be switched to the check mode for pocket folding. After the pocket material 0 is folded by the folder in step 7 above, the machine will return to standby mode. If the label 0 is poorly positioned, press the FOLDER RESET button m twice to return the folder assembly to the former state. If the label 0 has been folded properly, depress the left foot switch ®. After the presser foot assembly has moved, the main material 0 and the pocket material 0 are carried to the machine and sewing starts. (RESET mode is entered when the power is switched on.) -18-