Brother International BAS-760 Instruction Manual - English - Page 34
Brother International BAS-760 Manual
View all Brother International BAS-760 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
(9) Program the straight line ©- 0 by the method for programming a pattern containing numerous straight lines (position 0 is the starting point of the arc), on page 27. (10) Utilizing the smoothing function, specify the stitch length for the curve 0- ©- ® in the same way as described in steps (5) to (8) on the previous page. 789 1 key (11) Program the three straight lines from point © to final stitch by the method for programming a pattern containing numerous straight lines, on page 27. (12) Press ten-key El three times to indicate "111" on the STEP display, and then press the E key. At this time, the needle bar must be raised to the highest position. When U51 comes on, reset the alarm by pressing the EM STOP button and turn the pulley to raise the needle bar to the highest position once 0 more. At the point where the flashing U51 goes off for production piece display, press the START button. (13) The sewing clamp assembly returns to the initial stitch position ®. (14) Ensure that the sewing clamp assembly and the program number coincide, and write the program to the floppy disk (refer to page 38). (15) Press the E key; the sewing clamp assembly will return to the shunting position and then ascend. The displays X, Y and STEP will go off. Note 1: At steps (4), (9) and (11), instead of the procedures in Section 3, the lines may be programmed by utilizing the smoothing function between two points. Note 2: • Arbitrary point-4 When programming a pattern as illustrated on the left, be sure to press end-command keys fa E, E and n for an acute angle such as at point ®. If the end keys are not pressed, the corner will be round. Note 3: The maximum number of positions that can be loaded at a time is 60. If this is exceeded, the program will shift automatically into a stage where keys Eh O, E and El have been pressed, and the computer will start processing. Note 4: If a smoothing position close to the sewing area border is loaded, the sewing data may exceed the range. In this case, press keys El, E, E and E to sound the buzzer; the needle will return to the position where the El key was pressed and the loaded stitches will be canceled. -31-