Brother International Innov-is NQ1600E Operation Manual - Page 24
Winding/Installing the Bobbin
View all Brother International Innov-is NQ1600E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Winding/Installing the Bobbin Winding/Installing the Bobbin CAUTION • Only use the Bobbin (part code: SA156, SFB: XA5539-151) designed specifically for this machine. Use of any other bobbin may result in injuries or damage to the machine. • The included bobbin was designed specifically for this machine. If bobbins from other models are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same type (part code: SA156, SFB: XA5539-151). SA156 is Class15 type bobbin. Open the top cover. a Place the bobbin on the bobbin winder shaft so that the b spring on the shaft fits into the notch in the bobbin. Press down on the bobbin until it snaps into place. 1 2 * Actual size 1 This model 2 Other models 3 11.5 mm (approx. 7/16 inch) Winding the bobbin This section describes how to wind thread onto a bobbin. 1 Notch 2 Bobbin winder shaft spring Slide the bobbin winder in the direction of the arrow c until it snaps into place. • The "Start/Stop" button lights up in orange. Remove the spool cap that is inserted onto the spool d pin. 1 Memo • When winding bobbin for embroidery be sure to use the recommended bobbin thread for this machine. 2 1 Spool pin 2 Spool cap B-14