Brother International Innov-is NQ1600E Operation Manual - Page 95
Maintenance And Troubleshooting
View all Brother International Innov-is NQ1600E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Troubleshooting Error messages Cause/solution 9 Not enough available memory to save the pattern. Delete another pattern? This message is displayed when the memory is full and the pattern cannot be saved. OK to recall and resume previous memory? 10 This message appears if the machine is turned off while embroidering, then turned on again. Press to return the machine to the condition (pattern position and number of stitches) when it was turned off. Follow the procedure described in "If the thread breaks during sewing" on page E-24 to align the needle position and embroider the remainder of the pattern. 11 Pattern extends to the outside of embroidery frame. This message appears when the embroidery character pattern is edited, for example, rotated, so that it no longer fits within the embroidery frame. 12 Pattern extends to the outside of embroidery frame. Add no additional characters. This message appears when the embroidery character pattern is edited by adding a line feed so that it no longer fits within the embroidery frame. Pattern extends to the outside of embroidery frame. This message appears when the embroidery character pattern is resized or 13 This function cannot be used at this time. switched between written vertically/horizontally so that it is too large for the embroidery frame. 14 Preventive maintenance is recommended. This message is displayed when the machine needs to be maintained. (page A-3) Selected pattern field extends to the outside of the This message appears when the selected embroidery pattern is larger than embroidery frame. the extra large embroidery frame. Reduce the pattern size, or select a 15 different pattern. This message appears when the selected embroidery pattern is larger than the embroidery frame selected when "Embroidery Frame Identification View" is set to "ON". 16 The bobbin thread is almost empty. This message is displayed when the bobbin thread is running out. Follow the procedure described in "If the bobbin runs out of thread" on page E-23. 17 The bobbin winder safety device has activated. Is the thread tangled? This message is displayed when the bobbin is being wound, and the motor locks because the thread is tangled, etc. This message appears before embroidery unit moves. The carriage of the embroidery unit will 18 move. Keep your hands etc. away from the carriage. 19 The pockets are full. Delete a pattern. This message is displayed when the memory is full and a pattern must be deleted. This message is displayed when the motor locks due to tangled thread or for 20 The safety device has been activated. Is the other reasons related to thread delivery. thread tangled? Is the needle bent? 21 The USB media was changed. Do not change the USB media while it is being read. This message is displayed when you attempt to select a pattern after the USB flash drive in which the pattern is saved has been changed. There is a pattern included that cannot be saved to Depending on the pattern, it may not be possible to save it to a USB flash 22 USB media. Save the pattern in the machine's drive. memory. 23 This pattern cannot be used. This message appears when you try to retrieve a pattern that cannot be used with this machine. 24 This USB media cannot be used. This message is displayed when you try to use incompatible media. 25 USB media error This message is displayed when an error occurs with the USB flash drive. 26 USB media is not loaded. Load USB media. This message is displayed when you try to recall or save a pattern while no USB flash drive is loaded. F** 27 If error message "F**" appears in the LCD while the machine is being used, the machine may be malfunctioning. Contact your authorized dealer or the nearest Brother authorized service center. MAINTENANCE AND TROUBLESHOOTING A Appendix A-11