Brother International Innov-is NQ1600E Operation Manual - Page 27
Installing the bobbin
View all Brother International Innov-is NQ1600E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Winding/Installing the Bobbin Use scissors to cut the end of the thread wound around o the bobbin. Slide the bobbin winder shaft to the left, and then p remove the bobbin from the shaft. Press (Needle position button) once or twice to a raise the needle. Press . b • When the message "OK to automatically lower the presser foot? " appears on the LCD screen, press to continue. The screen changes, and all keys and operation buttons are locked (except ). Memo • If the bobbin winder shaft is set to the right side, the needle will not move. (Embroidering is impossible.) Remove the spool for the bobbin thread from the spool q pin. Raise the presser foot lever. c Slide the bobbin cover latch to the right. d 1 2 GETTING READY B Memo • When the machine is started or the handwheel is turned after winding the bobbin, the machine will make a clicking sound; this is not a malfunction. Installing the bobbin Install the bobbin wound with thread. You can begin embroidering immediately without pulling up the bobbin thread by simply inserting the bobbin in the bobbin case and guiding the thread through the slit in the needle plate cover. 1 Bobbin cover 2 Latch Remove the bobbin cover. e Hold the bobbin with your right hand with the thread f unwinding to the left, and hold the end of the thread with your left hand. Then, with your right hand, place the bobbin in the bobbin case. CAUTION • Use a bobbin that has been correctly wound with thread, otherwise the needle may break or the thread tension will be incorrect. • Before inserting or changing the bobbin, be sure to press on the operation panel to lock all keys and buttons, otherwise injuries may occur if the "Start/Stop" button or any other button is pressed and the machine starts. Basic operations B-17