Brother International Innov-is NQ1600E Operation Manual - Page 94
Error messages
View all Brother International Innov-is NQ1600E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
Troubleshooting Symptom Probable Cause Remedy Reference Embroidery pattern Fabric outside the frame edges interferes with does not sew out the sewing arm, so the embroidery unit cannot correctly. move. Fabric is too heavy, so the embroidery unit cannot move freely. Reinsert the fabric in the embroidery frame so that the excess fabric is away from the sewing arm, and rotate the pattern 180 degrees. B-30 Place a large thick book or similar object under - the arm head to lightly lift the heavy side and keep it level. Fabric is hanging off the table. If the fabric is hanging off the table during embroidery, the embroidery unit will not move freely. Place the fabric so that it does not hang off the table or hold the fabric to keep it from dragging. B-28 Fabric is snagged or caught on something. Stop the machine and place the fabric so that it - does not get caught or snagged. Embroidery frame was removed during sewing (for example, to reset the bobbin). The embroidery foot was bumped or moved while removing or attaching the embroidery frame, or the embroidery unit was moved. If the embroidery foot is bumped or the embroidery unit is moved during sewing, the pattern will not turn out. Be careful when removing or reattaching the embroidery frame during sewing. Stabilizer is incorrectly attached, for example, it Attach the stabilizer correctly. is smaller than the embroidery frame. B-33 B-29 Loops appear on the surface of the fabric when embroidering. The thread tension is incorrectly set. Adjust the thread tension. The combination of the bobbin case and bobbin Change the bobbin case or bobbin thread so thread is incorrect. that the correct combination is used. E-26 B-28 Error messages When erroneous operations are performed messages and advice on operation will be displayed on the LCD. Follow what is displayed. If you press or do the operation correctly while the error message is displayed, the message disappears. Error messages Cause/solution A malfunction occurred. Turn the machine off, then This message is displayed if some malfunction occurs. on again. Turn the machine off, then back on again. 1 If this message continues to appear, the machine may be malfunctioning. Please contact your authorized Brother dealer or the nearest Brother authorized service center. 2 Cannot change the configuration of the characters. This message is displayed when there are too many characters and the curved character configuration is impossible. 3 Cannot change the font since some letters are not included to the selected font. This message appears when the font of the embroidery character pattern is changed to one that does not include characters used in the pattern. Cannot recognize the data for the selected pattern. This message appears when you try to retrieve pattern data that is invalid. The data may be corrupted. Please turn off the Since any of the following may be the cause, check the pattern data. 4 power and turn on again. • The pattern data is damaged. • The data that you tried to retrieve was created using another manufacturer's data design system. Turn the machine off, then on again to return it to its normal condition. 5 Check and rethread the upper thread. This message is displayed when the upper thread is broken or not threaded correctly, and the "Start/Stop" button, etc. is pressed. 6 Data volume is too large for this pattern. This message is displayed when the patterns you are editing take up too much memory, or if you are editing too many patterns for the memory. 7 Lower the presser foot lever. This message is displayed when the "Presser foot lifter" button is pressed while the presser foot lever is raised/the needle is lowered. 8 Not enough available memory to save. This message is displayed when the memory is full and the pattern cannot be saved. A-10