Brother International Innov-is NQ1600E Operation Manual - Page 38
Embroidery Attractive Finishes
View all Brother International Innov-is NQ1600E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Embroidery Attractive Finishes Embroidery Attractive Finishes There are many factors that go into beautiful embroidery. Using the appropriate stabilizer (see page B-29) and hooping the fabric in the frame (see page B-30) are two important factors mentioned earlier. Another important point is the appropriateness of the needle and thread being used. See the explanation of threads below. ■ Thread Upper thread Bobbin thread Use embroidery thread intended for use with this machine. Other embroidery threads may not yield optimum results. Use embroidery bobbin thread intended for use with this machine. Note • Before embroidering, check that there is enough thread in the bobbin. If you start to sew your embroidery project without enough thread in the bobbin, you will need to rewind the bobbin in the middle of the embroidery pattern. Memo • If you use threads other than those listed above, the embroidery may not sew out correctly. ■ Bobbin case Bobbin case (recommended for embroidering with included 90 weight bobbin thread) CAUTION • When embroidering on large garments (especially jackets or other heavy fabrics), do not let the fabric hang over the table. Otherwise, the embroidery unit cannot move freely and the embroidery frame may strike the needle, causing the needle to bend or break and possibly cause injury. Place the fabric so that it does not hang off the table or hold the fabric to keep it from dragging. Note • Do not leave objects in the range of motion of the embroidery frame. The frame may strike the object and cause a poor finish to the embroidery pattern. • When embroidering on large garments (especially jackets or other heavy fabrics), do not let the fabric hang over the table. Otherwise, the embroidery unit cannot move freely, and the pattern may not turn out as planned. a 1 Bobbin case (no color on the screw) The bobbin case included with this machine has been set to be used with 90 weight bobbin thread. If different weights of bobbin threads are used the tension screw on this case can be adjusted if necessary. For details on adjusting thread tension, refer to "Adjusting thread tension" in the "Embroidering" section. • See "Cleaning the Race" in the "Appendix" section for how to remove the bobbin case. B-28