Brother International MFC 8300 Users Manual - English - Page 67

Dual Access You can scan up to 50 documents into the fax memory, even while the machine is receiving or sending another fax (from memory). You can set temporary settings for each fax you're scanning, except Timer and Polling. If you try to scan in and store a 51st fax, the machine will send it immediately, without storing it in memory. If you get a MEMORY FULL message while scanning the first page of a fax, press Stop to cancel scanning. If you get a MEMORY FULL message while scanning in a subsequent page, you'll have the option to press Start to transmit the pages scanned so far, or to press Stop to cancel the operation. 1 Make sure the document feeder is empty. 2 Place the document in the feeder. 3 Enter the fax number. 4 Press Start . The machine starts scanning the document and the screen displays the job number (#XX) of the fax and how much memory is available. Then the machine starts dialing. You can immediately repeat steps 1 through 4 for the next fax. Your machine normally operates in Dual Access mode. However, you can override Dual Access by using Real Time Transmission. The number of documents you can scan into memory varies with the data they contain. Real Time Transmission When Memory is full, the machine cannot continue to scan documents into memory before sending. However, you can turn on REAL TIME TX; place the documents in the feeder and enter the fax number. As soon as the phone line is free, the machine starts dialing and sending the fax. 1 Place the document in the feeder. 2 For the FAX, press Function , 3 , 9 . For the MFC, press Function , 1 , 3 , 9 . 3 To change the default setting, press or to select ON (or OFF) and press Set . Go to Step 5-OR- For the next fax transmission only, press or to select NEXT FAX ONLY and press Set . 4 For the next fax only, press or to select ON (or OFF) and press Set . 9.REAL TIME TX REAL TIME:ON? SELECT & SET SETUP SEND 6-3