Brother International MFC 8300 Users Manual - English - Page 90

Remote Commands Follow the commands below to access features remotely. When you call your machine and enter your Remote Retrieval Access Code (1 5 9 ), the system will signal you with two short beeps to enter a remote command. Remote Commands Operation Details 95 Changing Fax Forwarding/ Paging setting 1 OFF 2 Fax Forwarding 3 Paging If you hear one long beep, the change is accepted. If you hear three short beeps, you cannot change it because the conditions have not been met. (Example: registering paging 4 FAX FWD No. 6 Fax Storage ON 7 Fax Storage OFF number). You can register your fax forwarding number by using 4. FAX FWD NO (see page 9-6). Once you have registered the number, your machine will change automatically to FAX FWD:ON mode. Then retrieve a Memory Status List by entering 961 (see page 9-6) to make sure that the Fax Forwarding number you registered is correct on the List. You can set FAX STORAGE to ON or OFF. 96 Retrieve a fax 1 Memory Status List Enter the number of a remote fax machine to 2 Retrieve all faxes receive the Memory Status List or stored fax message(s). (See page 9-5.) 3 Erase fax from the memory If you hear one long beep, you can erase fax message(s) from the memory. 97 Check the receiving status 1 Fax You can check whether your machine has received any fax message(s). If yes, you will hear one long beep. If no, you will hear three short beeps. 98 Change Answer Mode 1 TAD 2 FAX/TEL 3 FAX 90 Exit If you hear one long beep, you can change the Answer Mode. If you hear three short beeps, you cannot change it. After a long beep, you can exit remote retrieval. 9-4 REMOTE FAX OPTIONS