Brother International ULT-2001 Users Manual - English - Page 142

CONTENTS 2. Attach presser foot "J" and sew straight stitches up to the zipper opening. Change to a basting stitch and sew 1 - 3 2 to the top of the fabric. 1 Reverse stitches 2 Wrong side of fabric 4 1 3 Basting stitches 4 End of zipper opening 2 - 1 3 4 5 1 2 3. Press the seam allowance open and align the folded hem along the teeth of the zipper, while maintaining 2 3 mm (1/8 inch) for the sewing space. 1 Zipper pull tab 2 Wrong side of fabric 3 Zipper teeth 4 End of zipper opening 5 3 mm (1/8 inch) 4. Remove presser foot "J". Align the right side of the pin 3 in zipper foot "I" with the presser foot holder, and attach the presser foot. 1 Right 2 Left 3 Needle drop position CAUTION When using zipper foot "I", make sure the straight stitch, middle needle position is selected. Turn the balance wheel to make sure the needle does not strike the presser foot. If another stitch is selected, the needle will strike the presser foot, causing the needle to break and possible leading to injury. 3 - 4 - 5 - 6 - 7 - 8 - 2 6 1 5. Set the presser foot in the 3 mm (1/8 inch) margin. Starting from the end of the zipper opening. Sew to a point about 50 mm (2 inch) from the edge of the fabric, then stop the machine. Pull down the zipper slider, then continue sewing to the edge of the fabric. 1 50 mm (2 inch) 2 3 mm (1/8 inch) CAUTION Make sure the needle does not strike the zipper during sewing. If the needle strikes the zipper, the needle may break, leading to injury. Sewing Utility Stitches 3-69 9 - ?! Index