Brother International ULT-2001 Users Manual - English - Page 42
Setting the Bobbin, the correct direction. If the thread unrolls in
View all Brother International ULT-2001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Setting the Bobbin Press § § § in that order to display a video example of the operation on the LCD (see page 1-21). Follow the steps explained below to complete the operation. CAUTION Setting the bobbin improperly may cause the thread tension to loosen, breaking the needle and resulting in injury. 1 Wound evenly 2 Wound poorly 1 2 1. Raise the presser foot lever. 1 2. Slide the bobbin cover latch to the right, and remove the bobbin cover. 1 Bobbin cover CONTENTS 1 - 2 - 3 - 4 - 3. Put the bobbin in the shuttle, making sure the thread unrolls as shown. 5 - CAUTION Be sure the bobbin is set so the thread unrolls in the correct direction. If the thread unrolls in the wrong direction, it may cause the thread tension to be incorrect or the needle to break. 6 - 7 - 4. Guide the thread through the groove, then pull the 1 thread toward you to cut off any excess. 1 Cutter 8 - 5. Replace the bobbin cover. Place the left tab in place (see arrow 1 at left), then press lightly on the right side (see arrow 2 at left) until the cover clicks into place. Note You can begin sewing without pulling up the bobbin thread. When you need to pull up the bobbin thread (free motion embroidery) see the illustrated directions on page 1-38. Setting Up 1-31 9 - ?! Index