Brother International ULT-2001 Users Manual - English - Page 305

ERROR MESSAGES CONTENTS If the machine is not properly set and the "Start/Stop" button or the "Reverse/Reinforcement Stitch" button is pressed, or if the operation procedure is incorrect, the machine does not start. An alarm sounds and an error message is displayed on the LCD. If an error message displays, follow the instructions in the message. 1 - Below is an explanation of 49 error messages. Refer to these when necessary (if you press or do the operation correctly while the error message is displayed, the message disappears). 2 - 1. This message is displayed when the motor locks due to tangled thread or for other reasons relate to thread delivery. 4. This message is displayed when the is touched without an embroidery card inserted. 3 - 4 - 2. This message is displayed when the presser foot is raised and the "Start/Stop" button, "Reverse/Reinforcement Stitch" button, or "Thread Cutter" button pushed. 3. This message is displayed when the upper thread is broken or not threaded correctly, and the "Start/Stop" button or the "Reverse/ Reinforcement Stitch" button is pressed. 5. This message is displayed when the embroidery unit initialization is started with the presser foot lever down. 5 - 6 - 6. This message is dis- played if the is touched when an unusable embroidery card is inserted. 7 - 8 - CAUTION Be sure to rethread the machine. If you press the "Start/Stop" button without rethreading the machine, the thread tension may be wrong or the needle may break and cause injury. 9 - ?! 9-10 Troubleshooting Index