Brother International ULT-2001 Users Manual - English - Page 210
ADJUSTMENTS DURING THE EMBROIDERY PROCESS, The Bobbin Runs Out of Thread
View all Brother International ULT-2001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 210 highlights
ADJUSTMENTS DURING THE EMBROIDERY PROCESS The Bobbin Runs Out of Thread When the bobbin begins to run out of thread during sewing, the message shown at left will display. If the pattern is nearly complete at this time, you can finish the pattern safely without changing the bobbin thread. If there is a large portion of the pattern left to finish, it is recommended to change the bobbin thread before continuing. If the message at left displays, follow the steps below. CONTENTS 1 - 2 - 1. Press the "Start/Stop" button to stop the machine. 2. Press the "Needle Position" button to raise the needle, and raise the presser foot lever. 3 - 4 - 1 2 5 - 3. Use scissors to cut the upper thread. 4. Remove the embroidery frame. Be careful not to apply strong force to the fabric at this time. Otherwise, the fabric may loosen in the frame. CAUTION Be careful not to bump the embroidery unit carriage or the presser foot when removing or attaching the embroidery frame. Otherwise, the pattern will not embroider correctly. 5. Insert a wound bobbin into the machine, then reattach the embroidery frame. 6. To return to the spot in the pattern where you stopped sewing, go to page 5-36 and follow the steps from #4. 6 - 7 - 8 - 9 - ?! Embroidery 5-35 Index