Canon 3543B001AA ZR Instruction Manual - Page 55

Searching the Tape (Photo Search/Date Search) E OFF VCR POWER W T 2 WIRELESS CONTROLLER WL-D67 SEARCH SELECT Using the Full Range of Features Move quickly through still pictures recorded anywhere on a tape (photo search) or between different days of recording (date search). • You can only use this function from the Remote Controller. 1. Press down and slide the POWER switch to VCR. • Press the SEARCH SELECT button to choose between photo/date search. • PHOTO SEARCH or DATE SEARCH is shown in the display for a few seconds. 2. Press the and buttons to move backwards or forwards through the still pictures or between different days of recording. • Press once to move to the start of the previous/next still picture or day on the tape. • For photo search you can press more than once to move to the corresponding still picture (up to a maximum of 10 times), e.g. press the button 5 times to move forward 5 still pictures. • PHOTO-SEARCH/DATE SEARCH appears in the middle of the display alongside the or /" or ^ mark and, for photo search, the number of photos to search through. The recording mode is also shown (SP/LP). Notes: • Press the 3 (stop) side of the multi-switch to end your search. • If you begin a search very close to the start of a recorded still picture during photo search, the camera may skip straight past it. • A date cannot be identified if the total recording time on that day was less than one minute. • Date search playback may start just before or after the beginning of the located section. • If the data code is not displayed correctly you will not be able to operate the date search correctly. • When you have set the REC ZONE for the World Clock, date search looks for the change in date based on the adjusted time. 56