Canon imagePROGRAF iPF6300S iPF6300S Basic Guide No.2 - Page 30

If Line Length Does Not Match Adjust the length of printed lines as follows. To ensure that lines in CAD drawings are printed at exactly the right length, use Adjust Length to adjust the amount that paper is advanced. There are two options in Adjust Length: AdjustmentPrint and Change Settings. • AdjustmentPrint After a test pattern is printed, you will measure the discrepancy based on the results of printing. • Change Settings No test pattern is printed. Instead, you will measure a document already printed to determine the discrepancy. Additionally, two modes are available in both AdjustmentPrint and Change Settings: A:High or B:Standard/ Draft. Choose the mode that suits your particular printing application. • A:High This setting is applied when Highest quality or High is selected in Print Quality in the printer driver. • B:Standard/Draft This setting is applied when Standard or Fast is selected in Print Quality in the printer driver. • Always check the Adj. Priority values before using Adjust Length. (→"Selecting a Feed Amount Adjustment Method (Feed Priority)," User's Guide) • Use paper of the same type and size for adjustment as you will use for printing. Items to Prepare • When Using Rolls An unused roll at least 10 inches wide High-precision ruler • When Using Sheets One sheet of unused paper of at least A4/Letter size High-precision ruler Perform adjustment as follows. 1 Load paper. (→ , Loading Rolls on the Roll Holder) (→ , Loading Rolls in the Printer) (→ , Loading Sheets in the Printer) • Always make sure the loaded paper matches the type of paper specified in the settings. Adjustment cannot be completed correctly unless the loaded paper matches the settings. 2 On the Tab Selection screen of the Control Panel, press ◄ or ► to select the Settings/Adj. tab ( ). Ready OK:Setting/Adj. Menu Maint.C Remain.: 80% Tot.Print Area(m2): 678 • If the Tab Selection screen is not displayed, press the Menu button. 30