Cisco 3560G 48TS Software Configuration Guide - Page 157

Chapter 8 Configuring Switch-Based Authentication Protecting Access to Privileged EXEC Commands Setting or Changing a Static Enable Password The enable password controls access to the privileged EXEC mode. Beginning in privileged EXEC mode, follow these steps to set or change a static enable password: Step 1 Step 2 Command configure terminal enable password password Step 3 Step 4 Step 5 end show running-config copy running-config startup-config Purpose Enter global configuration mode. Define a new password or change an existing password for access to privileged EXEC mode. By default, no password is defined. For password, specify a string from 1 to 25 alphanumeric characters. The string cannot start with a number, is case sensitive, and allows spaces but ignores leading spaces. It can contain the question mark (?) character if you precede the question mark with the key combination Crtl-v when you create the password; for example, to create the password abc?123, do this: Enter abc. Enter Crtl-v. Enter ?123. When the system prompts you to enter the enable password, you need not precede the question mark with the Ctrl-v; you can simply enter abc?123 at the password prompt. Return to privileged EXEC mode. Verify your entries. (Optional) Save your entries in the configuration file. The enable password is not encrypted and can be read in the switch configuration file. To remove the password, use the no enable password global configuration command. This example shows how to change the enable password to l1u2c3k4y5. The password is not encrypted and provides access to level 15 (traditional privileged EXEC mode access): Switch(config)# enable password l1u2c3k4y5 78-16156-01 Catalyst 3560 Switch Software Configuration Guide 8-3