Cisco 3560G 48TS Software Configuration Guide - Page 758

Configuring MSDP Chapter 33 Configuring MSDP Step 3 Step 4 Step 5 Step 6 Command Purpose access-list access-list-number {deny | permit} source [source-wildcard] Create an IP standard access list, repeating the command as many times as necessary. or or access-list access-list-number {deny | permit} protocol source source-wildcard destination destination-wildcard Create an IP extended access list, repeating the command as many times as necessary. • For access-list-number, the range is 1 to 99 for standard access lists and 100 to 199 for extended lists. Enter the same number created in Step 2. • The deny keyword denies access if the conditions are matched. The permit keyword permits access if the conditions are matched. • For protocol, enter ip as the protocol name. • For source, enter the number of the network or host from which the packet is being sent. • For source-wildcard, enter the wildcard bits in dotted decimal notation to be applied to the source. Place ones in the bit positions that you want to ignore. • For destination, enter the number of the network or host to which the packet is being sent. • For destination-wildcard, enter the wildcard bits in dotted decimal notation to be applied to the destination. Place ones in the bit positions that you want to ignore. Recall that the access list is always terminated by an implicit deny statement for everything. end Return to privileged EXEC mode. show running-config Verify your entries. copy running-config startup-config (Optional) Save your entries in the configuration file. To remove the filter, use the no ip msdp redistribute global configuration command. 33-10 Catalyst 3560 Switch Software Configuration Guide 78-16156-01