Cisco 3560G 48TS Software Configuration Guide - Page 492

Configuring IP ACLs Chapter 27 Configuring Network Security with ACLs Creating a Numbered Extended ACL Although standard ACLs use only source addresses for matching, you can use extended ACL source and destination addresses for matching operations and optional protocol type information for finer granularity of control. When you are creating ACEs in numbered extended access lists, remember that after you create the ACL, any additions are placed at the end of the list. You cannot reorder the list or selectively add or remove ACEs from a numbered list. Some protocols also have specific parameters and keywords that apply to that protocol. These IP protocols are supported (protocol keywords are in parentheses in bold): Authentication Header Protocol (ahp), Enhanced Interior Gateway Routing Protocol (eigrp), Encapsulation Security Payload (esp), generic routing encapsulation (gre), Internet Control Message Protocol (icmp), Internet Group Management Protocol (igmp), Interior Gateway Routing Protocol (igrp), any Interior Protocol (ip), IP in IP tunneling (ipinip), KA9Q NOS-compatible IP over IP tunneling (nos), Open Shortest Path First routing (ospf), Payload Compression Protocol (pcp), Protocol Independent Multicast (pim), Transmission Control Protocol (tcp), or User Datagram Protocol (udp). Note ICMP echo-reply cannot be filtered. All other ICMP codes or types can be filtered. For more details on the specific keywords relative to each protocol, refer to Cisco IP and IP Routing Command Reference for IOS Release 12.1. Note The switch does not support dynamic or reflexive access lists. It also does not support filtering based on the type of service (ToS) minimize-monetary-cost bit. Supported parameters can be grouped into these categories: TCP, UDP, ICMP, IGMP, or other IP. 27-10 Catalyst 3560 Switch Software Configuration Guide 78-16156-01