Cisco 3560G 48TS Software Configuration Guide - Page 206

Configuring 802.1X Authentication Chapter 9 Configuring 802.1X Port-Based Authentication Default 802.1X Configuration Table 9-1 shows the default 802.1X configuration. Table 9-1 Default 802.1X Configuration Feature Authentication, authorization, and accounting (AAA) RADIUS server • IP address • UDP authentication port • Key Switch 802.1X enable state Per-port 802.1X enable state Periodic re-authentication Number of seconds between re-authentication attempts Quiet period Retransmission time Maximum retransmission number Host mode Guest VLAN Client timeout period Authentication server timeout period Default Setting Disabled. • None specified. • 1812. • None specified. Disabled. Disabled (force-authorized). The port sends and receives normal traffic without 802.1X-based authentication of the client. Disabled. 3600 seconds. 60 seconds (number of seconds that the switch remains in the quiet state following a failed authentication exchange with the client). 30 seconds (number of seconds that the switch should wait for a response to an EAP request/identity frame from the client before resending the request). 2 times (number of times that the switch will send an EAP-request/identity frame before restarting the authentication process). Single-host mode. None specified. 30 seconds (when relaying a request from the authentication server to the client, the amount of time the switch waits for a response before resending the request to the client.) 30 seconds (when relaying a response from the client to the authentication server, the amount of time the switch waits for a reply before resending the response to the server. This setting is not configurable.) 9-10 Catalyst 3560 Switch Software Configuration Guide 78-16156-01