Cisco 3560G 48TS Software Configuration Guide - Page 61

Chapter 2 Using the Command-Line Interface Using Editing Features Table 2-5 Editing Commands through Keystrokes (continued) Capability Keystroke1 Purpose Press Esc Y. Recall the next buffer entry. The buffer contains only the last 10 items that you have deleted or cut. If you press Esc Y more than ten times, you cycle to the first buffer entry. Delete entries if you make a mistake Press the Delete or or change your mind. Backspace key. Erase the character to the left of the cursor. Press Ctrl-D. Delete the character at the cursor. Press Ctrl-K. Delete all characters from the cursor to the end of the command line. Press Ctrl-U or Ctrl-X. Delete all characters from the cursor to the beginning of the command line. Press Ctrl-W. Delete the word to the left of the cursor. Press Esc D. Delete from the cursor to the end of the word. Capitalize or lowercase words or capitalize a set of letters. Press Esc C. Capitalize at the cursor. Press Esc L. Change the word at the cursor to lowercase. Press Esc U. Capitalize letters from the cursor to the end of the word. Designate a particular keystroke as Press Ctrl-V or Esc Q. an executable command, perhaps as a shortcut. Scroll down a line or screen on displays that are longer than the terminal screen can display. Press the Return key. Scroll down one line. Note The More prompt is used for any output that has more lines than can be displayed on the terminal screen, including show command output. You can use the Return and Space bar keystrokes whenever you see the More prompt. Press the Space bar. Scroll down one screen. Redisplay the current command line Press Ctrl-L or Ctrl-R. if the switch suddenly sends a message to your screen. Redisplay the current command line. 1. The arrow keys function only on ANSI-compatible terminals such as VT100s. 78-16156-01 Catalyst 3560 Switch Software Configuration Guide 2-7