Cisco 3560G 48TS Software Configuration Guide - Page 478

Configuring SNMP Chapter 26 Configuring SNMP Table 26-5 Switch Notification Types Notification Type Keyword bgp bridge cluster config config-copy entity envmon flash hsrp mac-notification port-security rtr snmp stpx syslog tty vlan-membership vlancreate vlandelete vtp Description Generates BGP state change traps. This option is only available when the enhanced multilayer image is installed. Generates STP bridge MIB traps. Generates a trap when the cluster configuration changes. Generates a trap for SNMP configuration changes. Generates a trap for SNMP copy configuration changes. Generates a trap for SNMP entity changes. Generates environmental monitor traps. You can enable any or all of these environmental traps: fan, shutdown, supply, temperature. Generates SNMP FLASH notifications. Generates a trap for Hot Standby Router Protocol (HSRP) changes. Generates a trap for MAC address notifications. Generates SNMP port security traps. You can also set a maximum trap rate per second. The range is from 0 to 1000; the default is 0, which means that there is no rate limit. Generates a trap for the SNMP Response Time Reporter (RTR). Generates a trap for SNMP-type notifications for authentication, cold start, warm start, link up or link down. Generates SNMP STP Extended MIB traps. Generates SNMP syslog traps. Generates a trap for TCP connections. Generates a trap for SNMP VLAN membership changes. Generates SNMP VLAN created traps. Generates SNMP VLAN deleted traps. Generates a trap for VLAN Trunking Protocol (VTP) changes. Note Though visible in the command-line help string, the fru-ctrl and flash insertion and removal keywords are not supported. You can use the snmp-server host global configuration command to a specific host to receive the notification types listed in Table 26-5. 26-12 Catalyst 3560 Switch Software Configuration Guide 78-16156-01