D-Link DES-3326S Reference Manual - Page 113
create syslog host
UPC - 790069242755
View all D-Link DES-3326S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
DES-3326SR Layer 3 Fast Ethernet Switch CLI Reference Manual create syslog host Purpose Used to create a new syslog host. Syntax config syslog host [all/] {severity [i nf o rm at i o nal/warni ng/all]/ f ac i li t y [lo c al0/lo c al1/lo c al2/lo c al3/ lo c al4/lo c al5/lo c al6/lo c al7]/udp_po rt / ipaddress / state[enabled/disabled] Description Parameters The create syslog host command is used to create a new syslog host. all − Specifies that the command will be applied to all hosts. − Specifies that the command will be applied to an index of hosts. There are four available indexes, numbered 1 through 4. severity − Severity level indicator. These are described in the following: Bold font indicates that the corresponding severity level is currently supported on the switch. Numerical Code Severity 0 Emergency: system is unusable 1 Alert: action must be taken immediately 2 Critical: critical conditions 3 Error: error conditions 4 Warning: warning conditions 5 Notice: normal but significant condition Network Monitoring Commands 113