D-Link DES-3326S Reference Manual - Page 152
config bandwidth_control
UPC - 790069242755
View all D-Link DES-3326S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
DES-3326SR Layer 3 Fast Ethernet Switch CLI Reference Manual config bandwidth_control Purpose Used to configure bandwidth control on a by-port basis. Syntax config bandwidth_control {re_rate [no_limit/]/tx_rate [no_limit/]} Description The config bandwidth_control command configures bandwidth on a by-port basis. Parameters − Specifies a range of ports to be configured. The port list is specified by listing the lowest switch number and the beginning port number on that switch, separated by a colon. Then highest switch number, and the highest port number of the range (also separated by a colon) are specified. The beginning and end of the port list range are separated by a dash. For example, 1:3 would specify switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 − in numerical order. rx_rate − Specifies that one of the parameters below (no_limit or ) will be applied to the rate at which the above specified ports will be allowed to receive packets no_limit − Specifies that there will be no limit on the rate of packets received by the above specified ports. 152 QOS Commands