D-Link DES-3326S Reference Manual - Page 330
config ospf all
UPC - 790069242755
View all D-Link DES-3326S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 330 highlights
DES-3326SR Layer 3 Fast Ethernet Switch CLI Reference Manual config ospf all Purpose Used to configure all of the OSPF interfaces on the switch at one time. Syntax config ospf all {area /priority /he llo _i nt e rv al /dead_interval /authentication [none/simple /md5 ]/metric /state [enabled/disabled]} Description This command is used to configure all of the OSPF interfaces on the switch, using a single group of parameters, at one time. Parameters priority − The priority used in the election of the Designated Router (DR). A number between 0 and 255. metric − The interface metric (1 to 65535). Entering a 0 will allow automatic calculation of the metric. hello_interval − Allows the specification of the interval between the transmission of OSPF Hello packets, in seconds. Between 5 and 65535 seconds can be specified. The Hello Interval, Dead Interval, Authorization Type, and Authorization Key should be the same for all routers on the same network. dead_interval − Allows the specification of the length of time between the receipt of Hello packets from a neighbor router before the selected area declares that router down. An interval between 5 and 330 OSPF Configuration Commands